Abstract:A novel self-centering friction damper with variable slip stiffness (VSFD) is proposed to achieve ideal self-centering capability and limit the responses of the brace frame structure under the extremely rarely occurring earthquake (EROE), and its critical difference from the self-centering friction damper with constant slip stiffness (CSFD) is the hardening post-yielding stiffness. Through mechanical analysis, the VSFD exhibits ideal flag-shaped hysteretic behavior with the desired self-centering and energy dissipation capacity. The experimental study confirms that the hysteretic behavior of the VSFD is affected by friction coefficient, slope angle and transverse compressive force. The combination of disc spring stacks with various stiffness can provide variable compressive stiffness for the VSFD. The ratio of the residual sliding load to the initial sliding load increases with pre-compressive force, and so does the self-centering capacity. The hardening post-yielding stiffness ratio is proportional to the ratio of strong to weak stacks of the disc springs. The displacement corresponding to the hardening point decreases as the preloading weak stacks’ deformation capacity decreases. The VSFD can dissipate energy even if the deformation is small, and the damping ratio drops with increasing deformation, pre-compressive force and compressive stiffness. The updated displacement-based design procedure is proposed and the comparative dynamic time history analysis is conducted for the brace frames with different kinds of braces. The results show that the seismic responses of brace frames with the CSFDs and VSFDs are comparable under the rarely occurring earthquake (ROE), which meet the performance objectives, while the latter has smaller displacement response and larger floor acceleration than the former owing to its hardening post-yielding stiffness. Due to the considerable residual deformation under the ROE and EROE, the response of brace frame with the conventional friction dampers (CFDs) differs dramatically.

Slide Roof System for Dynamic Response Reduction

Performance-Based Seismic Design and Evaluation of Fused Steel Diagrid Frame

Robustness of slide-roof friction TMD to seismic spectrum frequency width and structural stiffness

Roof Isolation System a Vibration Absorber for Buildings

Seismic performance evaluation of a novel resilient steel frame with self-centering rocking columns and replaceable energy-dissipating connections for low-rise structures

Design of Passive Systems for Control of Inelastic Structures

Data‐Driven Structural Health Monitoring on Shaking Table Tests of a 3‐Story Steel Building with Sliding Slabs

Self-centering energy-absorbing rocking core system with friction spring damper: Experiments, modeling and design

Seismic isolation of buildings with sliding concave foundation (SCF)

Resetting response of precast segments with gently keyed interface under seismic action

Optimal control for vibration peak reduction via minimizing large responses

Dynamic responses of multi-story structural systems with separated gravity and lateral resisting systems under seismic action considering connection semi-rigidity effects

Development and application of replaceable self-centering energy dissipative braces

Damped rigid substructure system for seismic protection of structures

Enhancing seismic performance of brace frame using self-centering friction damper with variable slip stiffness

Response surface analysis and optimization of controlled rocking steel braced frames

An innovative re-centering SMA-lead damper and its application to steel frame structures

A SMA-based sliding friction damper for enhancing the transverse seismic performance of isolated bridges

Optimum Friction Factor for Roof-Friction Tuned Mass Damper

Seismic responses analysis of multi-story suspended floors system

Optimal softening and damping design for buildings