Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Room temperature direct oxidation of benzene to phenol using hydrogen peroxide in the presence of vanadium-substituted heteropolymolybdates

Amorphous Vanadium Oxide Supported on Activated Carbon Prepared by Dielectric Barrier Discharge as an Efficient and Stable Catalyst for Hydroxylation of Benzene to Phenol

Highly Selective Oxidation of Benzyl Alcohol to Benzaldehyde with Hydrogen Peroxide by Biphasic Catalysis

Cu-dopedmesoporous VO_x-TiO_2 incatalytic hydroxylation of benzene to phenol

Highly selective oxidation of benzene to phenol with air at room temperature promoted by water

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Catalytic Hydroxylation of Benzene to Phenol with Hydrogen Peroxide over Cesium Salts of Keggin-type Heteropoly Acids

Direct Hydroxylation of Benzene to Phenol Using H2o2 As an Oxidant over Vanadium-Containing Nitrogen Doped Mesoporous Carbon Catalysts

Electrocatalytic oxidation of toluene into benzaldehyde based on molecular oxygen activation over oxygen vacancy of heteropoly acid

Vanadium Supported on Graphitic Carbon Nitride As A Heterogeneous Catalyst for the Direct Oxidation of Benzene to Phenol

Two Robust Polyoxovanadate Clusters Having a Square-Prism V10Ox Core for Efficient Catalysis of Benzene Hydroxylation to Phenol

Catalytic oxidation of phenol with H2O2 over VOx/GaSiAlOx catalyst

Light‐Induced Efficient Hydroxylation of Benzene to Phenol by Quinolinium and Polyoxovanadate‐Based Supramolecular Catalysts

Selective Oxidation of Benzene to Phenol by FeCl3/mpg-C3N4 Hybrids

In Situ Hydrogen Peroxide Production for Selective Oxidation of Benzyl Alcohol over a Pd@Hierarchical Titanium Silicalite Catalyst

Facile Synthesis of Heterogeneous Recyclable Pd/CeO2/TiO2 Nanostructured Catalyst for the One Pot Hydroxylation of Benzene to Phenol

Kinetics of phenol hydroxylation reaction of open mesoporous TS-1 with high backbone titanium content

Research progress on the heterogeneous photocatalytic selective oxidation of benzene to phenol

Advances in Development of Vapor Phase Selective Oxidation of Toluene to Benzaldehyde

Enhancing Direct Hydroxylation of Benzene to Phenol on Fe1/PMA Single-Atom Catalyst: a Comparative Study of H2O2vs. O2-assisted Reactions

Hydroxylation of Benzene to Phenol on Cu X O Y @C with Hydrogen Peroxide