Abstract:TiO2 is a promising photocatalyst used in practical environmental remediation. TiO2 photocatalysts are usually implemented in two forms: suspended powder and immobilized thin films. A simple technique for fabricating TiO2 thin film photocatalyst was developed in this work. The fabricated TiO2 thin film photocatalyst featured a homogeneous nanowire layer grown in situ on the parent Ti plate. The optimized fabrication protocol was to soak the ultrasonically cleaned and acid-washed Ti plate in 30% H2O2 solution containing 3.2 mM melamine and 0.29 M HNO3 at 80 °C for 72 h and then anneal at 450 °C for 1 h. TiO2 nanowires with uniform diameters were homogeneously arrayed on the Ti plate surface. The thickness of the TiO2 nanowire array layer was 1.5 μm. The pore properties of the TiO2 thin film were close to those of P25. The band gap of the fabricated photocatalyst was 3.14 eV. The photocatalytic activity of the fabricated photocatalyst toward 10 mg/L RhB and 1 mg/L CBZ demonstrated greater than 60% degradation under 2 h UVC irradiation. The RhB and CBZ degradation efficiencies remained at a good level after 5 consecutive cycles. Mechanical wearing, such as 2 min sonication, will not lead to significant suppression of the photocatalytic activity. Photocatalytic RhB and CBZ degradation using the fabricated photocatalyst favored an acidic > alkaline > neutral environment. The presence of Cl- slightly suppressed the photocatalytic degradation kinetics. However, RhB and CBZ photocatalytic degradation kinetics were promoted in the copresence of SO42- or NO3-.

Synthesis of immobilized TiO2 nanowires by anodic oxidation and their gas phase photocatalytic properties

Titania Nanowires Synthesized by Thermal Oxidation of Ti Plates in Vacuum

Fabrication of Well-Aligned Tio2 Nanotube Arrays with Outstanding Light-Induced Hydrophilicity Performance

Preparation of Photocatalytic Anatase Nanowire Films Byin Situoxidation of Titanium Plate

Photocatalytic activity of TiO 2 nanorods, nanowires and nanoflowers filled with TiO 2 nanoparticles

Titania Nanoflowers with High Photocatalytic Activity

A facile synthesis of hierarchical TiO2 for dye adsorption and photocatalysis

Surface roughening and top opening of single crystalline TiO2 nanowires for enhanced photocatalytic activity

One-pot Hydrothermal Synthesis of the Dual-Phase Anatase/tio2-B Nanoparticles with K2Ti6O13 Nanofibers for Enhanced Photocatalysis

Direct Synthesis of Anatase Tio2 Nanowires with Enhanced Photocatalytic Activity

Fabrication and Photocatalysis of TiO2 Flower-like Nanostructures

Low‐Temperature Transformation of Titania Thin Films from Amorphous Nanowires to Crystallized Nanoflowers for Heterogeneous Photocatalysis

Photocatalytic Active Titania Nanowire Arrays on Ti Substrates

Fabrication and Photocatalytic Activity of Tio2 Nanofiber Membrane

Activation of Carbon Cloth and Concurrent Precipitation of Titania Nanowires for Enhanced Adsorption and Photocatalysis Performance

Facile Synthesis of Ni-doped TiO2ultrathin Nanobelt Arrays with Enhanced Photocatalytic Performance

Fabrication of an in situ-grown TiO2 nanowire thin film and its enhanced photocatalytic activity

Controllable Synthesis and Tunable Photocatalytic Activity of TiO2 Nanowires Via Alcohol-Thermal Method

ChemInform Abstract: Direct Synthesis of Anatase TiO2 Nanowires with Enhanced Photocatalytic Activity

Large-Scale Synthesis and Characterization of TiO2-Based Nanostructures on Ti Substrates

Fabrication of TiO2 Hierarchical Architecture Assembled by Nanowires with Anatase/tio2(b) Phase-Junctions for Efficient Photocatalytic Hydrogen Production