Abstract:Accumulation of electrostatic charges in gas–solid fluidized beds can lead to particle adhesions, electrostatic discharges, wall sheeting and even explosion. Therefore, it is of vital importance to reduce the electrostatic level in industrial fluidized beds. Adding chemical static agents was reported as one of the most promising ways to control fluidized bed electrostatic potentials. In this study, the electrostatic potential distributions were measured in a three-dimensional column gas–solid fluidized bed with the LLDPE particles for fluidization and the introduction of chemical static agents. Seven charge inducing agents including TiO2, Al2O3, MgO, H2O, C2H5OH, ZnO, and Fe2O3 were employed to investigate their influence on electrostatic potentials distribution respectively. Additionally, Al(Et)3, which is normally used as the cocatalyst for olefin polymerization, was also studied for comparison. It was found that the adding of negative charge inducing agent such as TiO2 made the positive electrostatic potentials shift to higher values and the negative electrostatic potentials shift to lower values. The injection of positive charge inducing agent such as Al2O3 and MgO caused the positive electrostatic potentials dropping to lower values and the negative electrostatic potentials shifting to the values near zero at low injection amount. Affecting mechanism of charge inducing agents was discussed based on the experimental results and the electronegativity of corresponding compounds. It was found that the electronegativity (χi) of the metal ion played an important role in determining the charge polarity on the LLDPE particles and the change in the electrostatic potentials after contact and separation with the charge inducing agent particles.

Influence of Powder Bed on Thermal Debinding Rate and Mass Transport Process

Thermal Debinding Dynamics in Ceramic Powder Injection Modling

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Electrostatic Potentials in Gas–solid Fluidized Beds Influenced by the Injection of Charge Inducing Agents

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

Theory and Practice of Rapid and Safe Thermal Debinding in Ceramic Injection Molding

Influence of Temperature and Compact Structure on the Mass Transport During Water Debinding in Ceramic Injection Molding

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

The thermal debinding of soluble binders in injection molded zirconia ceramic from room temperature to 250°C

Solvent Debinding Behavior of Zirconia Powder Injection Molding

Discrete Element Simulation of the Effect of Roller-Spreading Parameters on Powder-Bed Density in Additive Manufacturing

Kinetics for supercritical CO2 debinding of injection molded ZrO2

Surface Treatment and Modification of Al2O3 Powders

STUDY ON KINETICS FOR SUPERCRITICAL CO2 DEBINDING OF INJECTION MOLDED ZrO2 CERAMICS

Effect of fines addition on heat transfer performance in gas-solid fluidized bed: An integrated experimental, simulation, and theoretical study

Mechanism of Thermal Debinding and Water Debinding for Ceramic Injection Molding

Effect of the debinding method on the properties of injection molding ceramics

Thermal properties of powder beds in energy absorption and heat transfer during additive manufacturing with electron beam

Binder jetting additive manufacturing: Three-dimensional simulation of micro-meter droplet impact and penetration into powder bed

Gas and Powder Flow Characteristics of Packed Bed: A Two-way Coupled CFD-DEM Study