Abstract:In multi-layer powder spreading process of electron beam powder bed fusion (PBF-EB) additive manufacturing, the quantitative correlation between characteristics (actual height of the deposited layer, packing density, average surface roughness) of each spread powder layer and corresponding process parameters (set thickness value of the layer, spreading velocity) has not been well established. And the underlying mechanism is still not clear. For this objective, PBF-EB additive manufacturing of pure tungsten component in physical experiment is numerically reproduced by a validated coupled discrete element method-computational fluid dynamics (DEM-CFD) model, where the cumulative effects of process parameters are comprehensively analyzed through systematic parametric studies. The results show that with the increase of set thickness value of the layer, the number of layers that reaching steady state first decreases and then increases. After stabilization, the packing density and the average surface roughness of the powder bed are mainly determined by spreading velocity, while the actual height of the deposited layer is determined by both the packing density and the set thickness value of the layer. The mechanism can be ascribed to different motion behaviors of particles located in the top and bottom regions of a new powder layer induced by the impediment of the melted region in the powder bed. The bottom particles can be squeezed by strong forces to form a dense structure, while the top particles escape from the force arches to the zone consisted of weak forces before they are spread and their motion behaviors are dependent on their residual velocity. The obtained highlighted results are not only of theoretical significance, but also of practical value for parameter setting and optimization in the actual electron beam powder bed fusion additive manufacturing of pure W and other materials.

Thermal properties of powder beds in energy absorption and heat transfer during additive manufacturing with electron beam

Multiscale heat transfer affected by powder characteristics during electron beam powder-bed fusion

Non-equilibrium solidification behavior associated with powder characteristics during electron beam additive manufacturing

Non-Equilibrium Solidification Behavior With Solute Trapping Associated With Powder Characteristics During Electron Beam Additive Manufacturing

Processing condition dependency of increased layer thickness on surface quality during electron beam powder bed fusion

Laser-particle Interaction-Based Heat Source Model of Laser Powder Bed Fusion Additive Manufacturing

A semi-analytical approach for analysis of thermal behaviors coupling heat loss in powder bed fusion

Effect of varying preheating temperatures in electron beam powder bed fusion: Part I Assessment of the effective powder cake thermal conductivity

On thermal properties of metallic powder in laser powder bed fusion additive manufacturing

Energy Coupling Mechanisms and Scaling Behavior Associated with Laser Powder Bed Fusion Additive Manufacturing

Effects of the higher accelerating voltage on electron beam powder-bed based additive manufacturing of Ti6Al4V alloy

Thermal modeling of variable process parameter effects in powder bed fusion using electron beam

Influences of Powder Packing Density in Laser Powder Bed Fusion Metal Additive Manufacturing

Investigation of Laser-Powder Interaction in Laser Powder Bed Fusion Process in Additive Manufacturing

Actual state-of-the-art of electron beam powder bed fusion

Finite Element Analysis of Interaction of Laser Beam with Material in Laser Metal Powder Bed Fusion Process.

Laser-Particle Interaction-Based Analysis Of Powder Particle Effects On Temperatures And Distortions In Directed Energy Deposition Additive Manufacturing

Experimental Characterization and Computational Simulation of Powder Bed for Powder Bed Fusion Additive Manufacturing

A multiscale framework for the evaluation of thermal conductivity of sintered powder at the powder bed fusion with electron beam conditions

Hierarchical effects of multi-layer powder spreading in the electron beam powder bed fusion additive manufacturing of pure tungsten material

Multiphysics modelling of powder bed fusion for polymers