The Dynamic Recrystallization in a Hot Compressed Al‐Zn‐Mg‐Cu‐Sc‐Zr Alloy: the Role of Strain Rate
Zhihao Zhao,Jiwu Huang,Yonggang Chen,Shichao Liu,Chenglong Xu,Guofu Xu
DOI: https://doi.org/10.1002/adem.202301163
IF: 3.6
2023-09-28
Advanced Engineering Materials
Abstract:The effects of strain rates (0.001‐1 s‐1) on the microstructures and mechanical performance of the novel Al‐Zn‐Mg‐Cu alloy through hot compression at 300 °C were investigated in detail. With the increase of strain rate, the dislocation density increased from 0.06×1013 m‐2 to 3.77×1013 m‐2, which promoted the dynamic precipitation kinetics. And the volume fraction of η precipitates was calculated by the DSC curves increasing from 1.36% to 3.94%. Both dislocations and precipitates promoted to increase the hardness of the Al‐Zn‐Mg‐Cu alloy. The large number of η precipitates in high strain rate samples hindered the recrystallization process by impeding the movement of dislocations and grain boundaries, decreasing the volume fraction of recrystallized grains to 3.1%. Continuous/discontinuous dynamic recrystallization occurred preferentially at low strain rates, and discontinuous dynamic recrystallization were rarely observed in high strain rate samples. In addition, because the process of continuous dynamic recrystallization promoted the transformation from low angle grain boundaries to high angle grain boundaries, more continuous dynamic recrystallized grains and less low angle grain boundaries could be observed in low strain rate samples. This article is protected by copyright. All rights reserved.
materials science, multidisciplinary