The serial communication system simulation based on proteus

Chen Jun

DOI: https://doi.org/10.3969/j.issn.1001-9227.2012.04.022

2012-01-01

Abstract:This paper studies the serial interface way of based on Proteus software through typical examples.It realizes the serial interface communication of the Microcomputer and MCU.

What problem does this paper attempt to address?

Based on the single chip microcomputer proteus the A/D transformation design and simulation

CHEN Jun,LIAN Yu-ping,GOU Shuang-quan

DOI: https://doi.org/10.3969/j.issn.1001-9227.2012.02.058

2012-01-01

Abstract:For Protues of abundant simulation models of component and the powerful function of simulation,a new way is presented to A/D conversion of MCU.The diagram schematics are figured out by making use of ADC0808 chip,AT89C52 and 7SEG displayer,and tests are given on the simulation by integrating Keil software,simulation effect of circuit can be observed in a direct and clear way.That reaches the aim of design.
Study on Simulation and Mathematical Model of RLC Serial Second-Order Circuit Based on Proteus

CHEN Jun

DOI: https://doi.org/10.3969/j.issn.1001-988x.2013.03.011

2013-01-01

Abstract:The paper discusses the resolving of the mathematical model of the RLC serial circuit second order differential equation in time domain and algebraic equation in complex domain,and establishes circuit model through Proteus software.The zero-state response of a second order series RLC circuit under over,critical and less then damping are studied.The processor of change and dischange performed are discussed by graphic table and virtual oscilloscope respectively.
Practice studying of the integration of the Proteus simulation technology and Microcomputer Principle and Interface Technology teaching

陈军

DOI: https://doi.org/10.3969/j.issn.1001-9227.2013.04.092

2013-01-01

Abstract:Information technology is widely used in teaching, the learners study way are changed by information technology.The good teaching situation can be created using Proteus simulation technology.The paper states that it can effectively help students construct the concept, rule, stimulate students' interest in learning, cultivate the students' subject quality, improve the students' using simulation technology design and development system of the comprehensive ability by the organic combination of practical teaching activities based on Proteus simulation software and microcomputer principle and interface technology.
Practicing Exploration on Integrated Teaching of Proteus Simulation Technology and Analog Circuit

陈军

DOI: https://doi.org/10.3969/j.issn.1007-2934.2012.03.031

2012-01-01

Abstract:From the digital circuit classroom teaching practice,based on asynchronous four bit binary counter as an example,the use of the circuit design Proteus,simulation method is discussed.
Application of Proteus on Teaching of Course of Microcomputer Principle

田社平,俞水锋,方向忠,茅旭初

DOI: https://doi.org/10.3969/j.issn.1008-0686.2011.05.025

2011-01-01

Abstract:This paper introduces application of software Proteus on the teaching of course of Microcomputer Principle and Interface Technology. As an example, Proteus is used to simulate the serial communication interface circuit based on 8086 CPU. Simulation steps and issues are discussed. It is concluded that it is helpful to introduce Proteus to teaching of the course for deepening students＇ understanding of microcomputer and interface technology, enhancing ability of research and interests of learning. The discussion is useful for the teaching of Microcomputer Principle and Interface Technology.
Application of Proteus in Experiment Teaching of MCU

赵洋,江维,王佳昊,蓝天

DOI: https://doi.org/10.3969/j.issn.1672-4550.2011.05.006

2011-01-01

Abstract:The characteristics and functions of Proteus are introduced in this paper and a typical experiment of single-chip is constructed with 89S52.Through design of a water temperature collection system and its realization,this paper expounds the detailed process of the single-chip and the periphery component's simulation by using Proteus.This method is easy to realize and the simulation process is direct-viewing.So it provides a good teaching method for the single-chip experiment.
Implementation of Serial Communication between PLC and Single-chip Microcomputer

Cheng Liang,Lin Bin,Cha Lingzhi

DOI: https://doi.org/10.3969/j.issn.1000-3886.2006.03.013

2006-01-01

Abstract:This paper introduces serial communication between PLC and single-chip microcomputer with the example of S7-226 PLC and AT89S51 MCU.Detailed explanation of hardware configuration and program design in this communication system is given.The design project in paper has been applied successfully in automatic pill-filled machine.
Serial Communication and Database Design Used in Eddy Current Testing System

Zhou Ze-kui

2007-01-01

Abstract:A serial communication protocol used in the eddy current testing system is designed.Use the same format of data package to send out different kinds of command data.By identifying the special byte,the different command and data can be distinguished,a serial communication database also is designed,all these are realized using the graphical language.The application shows it has a good performance.
MCU-based Proteus System Design and Application of Simulation

Wu Zhengnan,Cheng Yuansheng

DOI: https://doi.org/10.3969/j.issn.1672-9722.2011.11.046

2011-01-01

Abstract:Specialty courses in digital control teaching,laboratory construction microcontroller hardware emulator to use more compatible with the experimental plate the way,this way not only need to purchase a large number of hardware devices,the use of process equipment maintenance workload is large,Update cost is higher,resulting in some schools is still based on 8031 microcontroller lab,as it is now applied generally AVR,PIC,ARM,etc.can not be added in time,resulting in a lack of knowledge of students.This paper presents a software simulation of the microcontroller based laboratory construction program.Just configure the program with limited hardware devices,can be a good solution to the funding gap,renewal of equipment,maintenance and other issues.After several years of operation,achieved good teaching effect,is to promote the use of high value laboratory construction program.
Study on the Real-Time Serial Communication Based on Windows

陈月斌,邬义杰,刘楚辉

DOI: https://doi.org/10.3969/j.issn.1001-2265.2003.12.003

2003-01-01

Abstract:Aiming at the real-time property of serial communication between upper and lower computer of distributed control system under Windows, based on the study on VxD work characteristic and the mechanism of serial communication, this paper describes the programming method of real-time serial communication,by using VtoolsD tool, which is good solution to the key technology of developing control system of precision machining.
Application of Proteus Simulation in Electronic and Information Engineering Specialty

Hui Li,Ming Zhao,Yuru Zhang,Xiaodong Su,Haitao Jiang

DOI: https://doi.org/10.2991/icemaess-18.2018.48

2018-01-01

Abstract:This article researches the application of Proteus simulation in Electronic and Information Engineering specialty.The relevant practice teaching of the course has been cascaded, can not only help students to link up theory knowledge, and also inspire further the enthusiasm and motivation of scholars.Based on Proteus, this paper introduces some cases to connect the practical teaching of several related courses of electronic information engineering.This teaching method has been proved that it not only ensures the continuity of knowledge, but also no affection in the course independence and expansibility.Above all, it improves students' interest in learning and exploration motivation.
Application of Proteus simulation software in the teaching experiment in embedded system

Zhang Yan,Xia QingFeng,Xie PengFei

DOI: https://doi.org/10.3969/j.issn.1674-9324.2015.43.116

2015-01-01

Abstract:Some problem was exist in embedded systems teaching,such as the presence is not strong,issues such as lack of student ability. In order to better improve students' innovative,Proteus and keil were used in teaching in order to make embedded systems more figurative theoretical teaching and improve student learning enthusiasm. Platform makes for experimental teaching equipment requirements reduced,saving the cost of the experimental teaching.
Realization of Serial Port Communication in Wireless Command System

WEI Gao

DOI: https://doi.org/10.3969/j.issn.1671-654X.2006.01.009

2006-01-01

Abstract:The paper introduces the operational principle of wireless command system and the important position of serial port communication in the system,and analyses the realization mechanism of serial port communication in Windows32,kinds of realization methods and programming ideas.Based on VC++6.0,the asynchronous communicational program on computer compiled by transferring Windows32 API,and the communicational program on single chip compiled with assemble language,combining the example of wireless command system,realize the communication between PC and single chip.The effect of communication is very good.
Application of Proteus in the Teaching of Computer Control Technology

hongqian lu,chunmei duan

DOI: https://doi.org/10.2991/icssr-14.2014.86

2014-01-01

Abstract:Computer Control Technology is an important course for university students of electrical engineering and automation major. This paper analyzes the problems in traditional way of teaching by introducing Proteus simulation software in teaching. We analysis in detail the application of Proteus in teaching through a teaching examples. We believe that software simulation of teaching examples will improve the overall design capabilities of computer control system of students.
Design of UVA Onboard Equipments Serial Communication Test System

Zhang lei,Zhang Xiaolin,Yang Baiping

DOI: https://doi.org/10.16526/j.cnki.11-4762/tp.2010.01.071

2010-01-01

Abstract:Serial communication is widely used in data transmission in UVA onboard equipments.For meeting the serial communication test requirement of UVA onboard equipments,designed and has constructed the test system of serial communication of UVA onboard equipments which is based on the PXI platform and take LabWindows/CVI as the software platform.This system has serial data unpack data display of human-computer interaction and function of seting pack send.This paper has analyzed how to use LabWindows/CVI construct the serial communication test system of human-computer interaction.Experimental results indicate that this system has tested the good engineering application prospects in serial communication test system of UVA onboard equipments.
The design and virtual simulation of MCU system based on I~2C bus

Xie Jing

Abstract:At present,MCS51 series,ATMEL89 series,68HC05 series microcontroller applications is very broad,but they did not I2C bus interface,limiting the use of these systems with I2C bus interface device applications.This paper introduces the interface design and programming of A/D conversion based on I2C Bus and the model for MCU system under Proteus simulation environment.At last,simulation was made about the A/D conversion based on I2C Bus.

Computer Science,Engineering
Simulation of LCD Module Based on Proteus

Dong-xun LI,Wen-hao SHEN,Xiao-quan CHEN

DOI: https://doi.org/10.3969/j.issn.1008-0570.2009.13.090

2009-01-01

Abstract:This paper has introduced the structure of LM06L,and the instructions of HD44780 which is a dot-matrix liquid crystal display controller.In this paper,the interface between LM06L and MCU 80C51,the driver of HD44780 and the display of our own defined characters are introduced.Finally,the debug steps by Proteus are described in a nutshell.
Principle of Ethernet-serial Port Sever Based Microcontroller

Jianxiao Wang

2007-01-01

Abstract:This paper introduces a new method that transmit data transparently between Ethernet and serial interface.It makes the Ethernet connected with the microcomputer unit.Using this method,we can make every kind of non-computer automatic equipment which is online.
Study of RS-485 Bus Ethernet Interface Conversion Device

GONG Quan-cheng,WU Ya-feng,LI Jiang-hong

DOI: https://doi.org/10.3969/j.issn.1000-3428.2012.22.062

2012-01-01

Abstract:Earlier serial port and Ethernet interface conversion is realized by pure hardware.It has features of high data transmission speed,but function single as well as poor flexibility.Due to these disadvantages,interface conversion system based on ARM9 is proposed.MOXA UC-7101 is utilized as hardware.Application program is developed under μCLinux embedded OS.System communication follows modbus protocols.When net is connected,SD card data can be retrieved correctly according to net instruction,and data between monitor center and lower RTU can be transferred correctly and timely.System test results show that MOXA begins to poll RTU and response data is stored into SD card while net is shut off.
The design and simulation of a digital electronic clock system based on Proteus and Keil

Yuan Qiu-feng

Abstract:Proteus and Keil are the main tools for developing single chip microcomputer systems.They have such characteristics as saving cost,reducing development cycle and increasing success rate of design.In this paper,a digital electronic clock system is designed and simulated,with AT89C51,DS1302 and LCD 1602 as the main components.

Computer Science,Engineering

The serial communication system simulation based on proteus

Based on the single chip microcomputer proteus the A/D transformation design and simulation

Study on Simulation and Mathematical Model of RLC Serial Second-Order Circuit Based on Proteus

Practice studying of the integration of the Proteus simulation technology and Microcomputer Principle and Interface Technology teaching

Practicing Exploration on Integrated Teaching of Proteus Simulation Technology and Analog Circuit

Application of Proteus on Teaching of Course of Microcomputer Principle

Application of Proteus in Experiment Teaching of MCU

Implementation of Serial Communication between PLC and Single-chip Microcomputer

Serial Communication and Database Design Used in Eddy Current Testing System

MCU-based Proteus System Design and Application of Simulation

Study on the Real-Time Serial Communication Based on Windows

Application of Proteus Simulation in Electronic and Information Engineering Specialty

Application of Proteus simulation software in the teaching experiment in embedded system

Realization of Serial Port Communication in Wireless Command System

Application of Proteus in the Teaching of Computer Control Technology

Design of UVA Onboard Equipments Serial Communication Test System

The design and virtual simulation of MCU system based on I~2C bus

Simulation of LCD Module Based on Proteus

Principle of Ethernet-serial Port Sever Based Microcontroller

Study of RS-485 Bus Ethernet Interface Conversion Device

The design and simulation of a digital electronic clock system based on Proteus and Keil