Abstract:To promote the innovation of raw magnesium production technology, an integrated calcination and silicothermic reduction short process for magnesium production was experimentally studied on the laboratory scale in this article. The influences of the thermal decomposition temperature, silicothermic reduction temperature, pelletizing pressures and silicon ratio on the characteristics of producing the magnesium by the short process was studied. The crosslinking effect, including reactions between CO2 decomposed from dolomite and metal elements in ferrosilicon, microstructure change at thermal decomposition and silicothermic reduction stages, was analyzed and discussed. In addition, comparison of the magnesium reduction rate and production efficiency between the new short process and the traditional Pidgeon process was made. The results indicated that the decomposition and reduction temperatures have a more significant influence on the magnesium reduction process than the pelletizing pressure and silicon ratio. A decomposition temperature < 1000 °C and reduction temperature > 1100 °C was proven to be favorable for improving the magnesium reduction rate and production efficiency of the new short process. It was also found that the integrated short process for magnesium production can reach the same total reduction rate and has lower efficiency compared to the traditional process. The decrease of magnesium production efficiency in the new short process was expected to result from reduction of the contact area and hindering of diffusion between CaO·MgO molecules and Si(Fe) atoms because of the microstructure change and ferrosilicon consumption by the reactions between CO2 and metal elements in ferrosilicon. Preparing briquettes with additives of binder or ultrafine particles of raw materials was proposed and considered for further study to improve the production efficiency.

Manufacturing Process of Activated Magnesia from Bittern and Dolomite

Fabrication of Y2O3-doped MgO Refractory Raw Materials Based on Magnesium Hydroxide from Salt-Lake Brine

Preparation of Active Magnesia with Magnesite

Activated Sintering of Activated Carbon-Doped Magnesia

Study of Carbonizing Processes for Sintered Dolomite

Research on preparation of high purity magnesite from MgCl2·6H2O

Thermal Decomposition Kinetics of Dolomite in Pre-prepared Pellets for Magnesium Production

Experimental Study of Magnesium (Mg) Production by an Integrated Calcination and Silicothermic Reduction Short Process

Magnesium Production from Calcined Dolomite via the Pidgeon Process

Activated treatment of magnesite for preparing size-controlled Mg2B2O5 whiskers and their microwave dielectric properties

Preparation technology and microstructural changes of low-activity magnesium oxide based on salt lake bischofite

A Technology of Preparing Honeycomb-Like Structure Mgo from Low Grade Magnesite

Preparation of Magnesium Hydroxide Chloride Hydrate Nanowires Using Calcined Dolomite

Reaction characteristics of magnesium production under argon flow by silicothermic reduction and numerical simulation of argon entrainment process

Carbon dioxide emission during the production of magnesium binders based on dolomitized rocks

High-purity vaterite CaCO 3 recovery through wet carbonation of magnesium slag and leaching residue utilization in cement

Novel Efficient Reduction Route for Magnesium Production Using Silicothermic Process

Kinetics of extracting magnesium from prefabricated pellets by silicothermic process under flowing argon atmosphere

Preparation and Characterization of Microporous Magnesia‐based Refractory

Distribution of impurities in magnesium via silicothermic reduction

Preparation of magnesium hydroxide by ammonia gas method