Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

The Relation Between Formation of Compounds and Glass Forming Ability for Zr–Al–Ni Alloys

On the atomic structure of Zr–Ni and Zr–Ni–Al metallic glasses

Glass-forming ability and thermal stability of Gd55-xNd xCo20Al25 metallic glass

Glass-Forming Ability and Thermal Properties of Al70Fe12.5V12.5X5(X = Zr, Nb, Ni) Amorphous Alloys via Minor Alloying Additions

An ab initio simulation and experimental studies of the glass-forming ability and properties of Al86Ni(14-x)Zrx (x = 1∼7) alloys

Structure of the amorphous, massive-metallic-glass forming Ni 25 Zr 60 Al 15 alloy from molecular dynamics simulations

Formation, Thermal Stability and Mechanical Properties of Zr-Nb-Cu-Ni-Al Bulk Metallic Glasses

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations

Chemical short-range order domain in bulk amorphous alloy and the prediction of glass forming ability

Glass-Forming Ability And Atomic-Level Structure Of The Ternary Ag-Ni-Zr Metallic Glasses Studied By Molecular Dynamics Simulations

Bulk Nanostructure Formation Directly From The Multicomponent Alloy Melt

Unusual Solidification Behavior of a Zr–Cu–Ni–Al Bulk Glassy Alloy Made from Low-Purity Zr

Structural Properties and Thermal Stability of Glassy (Zr.65al.075cu.175ni.1)100-Xfex (x≤20) Alloys Prepared by Mechanical Alloying

Effect of Cr on solidification structure and microhardness of Al-Ni alloy

Improving Glass Forming Ability of Off-Eutectic Metallic Glass Formers by Manipulating Primary Crystallization Reactions

Structural Properties and Thermal Stability of Glassy (Zr<sub>.65</sub>Al<sub>.075</sub>Cu<sub>.175</sub>Ni<sub>.1</sub>)<sub>100-x</sub>Fe<sub>x</sub> (x≤20) Alloys Prepared by Mechanical Alloying

Formation of a Ni- and Be-free Zr-based glassy alloy in centimeter scale

Effects of Mo Addition on the Metallic Glass Formation of (zrni)100−xmox Alloys

Favored Composition Region for Metallic Glass Formation and Atomic Configurations in the Ternary Ni–Zr–Ti System Derived from N-Body Potential Through Molecular Dynamics Simulations

Formation of Ni–Nb–Zr–X (X = Ti, Ta, Fe, Cu, Co) Bulk Metallic Glasses

The effect of minor alloying on the glass forming ability and crystallization reaction of Ti32.8Zr30.2Cu9M5.3Be22.7 (M=Fe, Co, and Ni) bulk metallic glass