Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

Glass-Forming Ability and Thermal Properties of Al70Fe12.5V12.5X5(X = Zr, Nb, Ni) Amorphous Alloys via Minor Alloying Additions

On the atomic structure of Zr–Ni and Zr–Ni–Al metallic glasses

Formation, Thermal Stability and Mechanical Properties of Zr-Nb-Cu-Ni-Al Bulk Metallic Glasses

Structural Properties and Thermal Stability of Glassy (Zr<sub>.65</sub>Al<sub>.075</sub>Cu<sub>.175</sub>Ni<sub>.1</sub>)<sub>100-x</sub>Fe<sub>x</sub> (x≤20) Alloys Prepared by Mechanical Alloying

An ab initio simulation and experimental studies of the glass-forming ability and properties of Al86Ni(14-x)Zrx (x = 1∼7) alloys

Structural Properties and Thermal Stability of Glassy (Zr.65al.075cu.175ni.1)100-Xfex (x≤20) Alloys Prepared by Mechanical Alloying

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations

Effects of Alloying Elements on Crystallization Kinetics of Ti–Zr–Be Bulk Metallic Glass

The effect of minor alloying on the glass forming ability and crystallization reaction of Ti32.8Zr30.2Cu9M5.3Be22.7 (M=Fe, Co, and Ni) bulk metallic glass

Study on isothermal crystallization kinetics of Zr55.7Cu22.4Ni7.2Al14.7 bulk amorphous alloy

Structure of the amorphous, massive-metallic-glass forming Ni 25 Zr 60 Al 15 alloy from molecular dynamics simulations

Al-based amorphous alloys: Glass-forming ability, crystallization behavior and effects of minor alloying additions

PREPARATION AND PROPERTIES OF BULK AMORPHOUS Fe-Ni-P-B-Ga ALLOYS

Crystallization and mechanical behavior of (Hf, Zr)–Ti–Cu–Ni–Al metallic glasses

Glass-Forming Ability And Atomic-Level Structure Of The Ternary Ag-Ni-Zr Metallic Glasses Studied By Molecular Dynamics Simulations

Formation of Ni–Nb–Zr–X (X = Ti, Ta, Fe, Cu, Co) Bulk Metallic Glasses

Effect of Fe addition on the glass-forming ability, stability, and mechanical properties of Zr50Cu34-xFexAl8Ag8 metallic glasses

Tuning Glass Formation and Mechanical Properties of ZrCoAl(Nb) Bulk Metallic Glass with Nb Microalloying Process

Crystallization behavior of ZrAlNiCu bulk metallic glass with wide supercooled liquid region

Glass-Forming Ability, Mechanical Properties, and Energetic Characteristics of ZrCuNiAlNbHfY Bulk Metallic Glasses

Mechanism of Ag and Al on improving the glass forming ability of CuZr-based alloys