Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

Effects of Mo Addition on the Metallic Glass Formation of (zrni)100−xmox Alloys

On the atomic structure of Zr–Ni and Zr–Ni–Al metallic glasses

Experimental and Theoretical Studies on Composition Limits of Metallic Glass Formation in the Ni-Mo System

Atomistic modeling to optimize composition and characterize structure of Ni-Zr-Mo metallic glasses.

Metallic Glass Formation in the Ternary Ni-Nb-Mo System by Ion Beam Mixing

Effects of Mo on the Glass Forming Ability and Properties of Fe-B-C-P-Si-Mo Bulk Metallic Glasses

Glass-forming Ability Determined by the Atomic Interaction Potential for the Ni-Mo System

Effects of Mo Additions on the Glass-Forming Ability and Magnetic Properties of Bulk Amorphous Fe-C-Si-B-P-Mo Alloys

Partitioning Behavior and Lattice Misfit of Γ/γ′ Phases in Ni-based Superalloys with Different Mo Additions

Formation and structural anomaly of the metastable phases in an immiscible Ag - Mo system studied by ion beam mixing and molecular dynamics simulation

Effect of Cr/Mo content on the properties of transition-metal based high entropy bulk metallic glasses

Glass-forming Range of the Ni–Mo System Derived from Molecular Dynamics Simulation and Generalized Lindemann Criterion

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations

Effects of Mo Addition on Microstructure of a 4th Generation Ni-based Single Crystal Superalloy

Formation and mechanical properties of Cu_(58)Zr_(20)Ti_(20)Mo_2 bulk metallic glass

Glass-Forming Ability and Thermal Properties of Al70Fe12.5V12.5X5(X = Zr, Nb, Ni) Amorphous Alloys via Minor Alloying Additions

Metastable phase formation and transformation studied by ion mixing and computation for the Cu–Zr–Ni system

Metallic glass formation in Cu–Ni–Ti (Zr, Hf) systems studied by thermodynamic calculations

Formation, Thermal Stability and Mechanical Properties of Zr-Nb-Cu-Ni-Al Bulk Metallic Glasses

Effect of Ag substitution for Ti on glass-forming ability, thermal stability and mechanical properties of Zr-based bulk metallic glasses

Formation of Ni–Nb–Zr–X (X = Ti, Ta, Fe, Cu, Co) Bulk Metallic Glasses