Abstract:The residual stress of mismatch seal between borosilicate glass 3.3 and stainless steel is analyzed for metal–glass solar evacuated tubes in this paper. As borosilicate glass has a much lower limit of stress than metal, a tube model with different sizes and shapes of metal and glass is simulated to determine the magnitude and profile of the residual stress in the glass region. The simulation results show that the maximum magnitude of the hazardous tensile stresses occurs at a few millimeters above the sealing area, not in the contact position; and the thickness of metal is the most important parameter of the seal which affects the stress level. The stress magnitude increases dramatically when the thickness of stainless steel increases from 10 to 60µm. Therefore, to avoid breakage of the seal, the thickness of metal should be less than 40µm. In addition, it is shown that both the cross-section shape of the metal ring and the contact length in the glass have a considerable impact on the stress. The stress level increases significantly with the increase of depth of the metal ring embedded in the glass. Comparison between a metal ring with trapezoidal cross-section and one with rectangular cross-section of equivalent mean thickness reveals that the former leads to smaller residual stress. Furthermore, the results show that variation in the glass tube dimensions, in compare to the metal ring parameters, has less effect on the residual stress level in the seal area. An increase in the thickness of the glass tube decreases the stress noticeably, whereas an increase in tube radius has a negligible impact. Finally, it is shown that the simulation results are in good accordance with results of experiments using samples of mismatch seal between borosilicate glass 3.3 and stainless steel successfully fabricated according to our proposed parameters.

Analysis on temperature field and thermal stress of platinum leaking tube for magneto-optic molten glass based on ANSYS

Finite Element Analysis on Non-Isothermal Glass Molding

Magneto-Thermo-Elastic Theoretical Solution for Functionally Graded Thick-Walled Tube under Magnetic, Thermal and Mechanical Loads Based on Voigt Method

Influences of Model’s Shape on Molding Time in Glass Molding Press

Application of Orthogonal Test in Numerical Simulation of Glass Lens Molding

Analysis of residual stress for mismatch metal–glass seals in solar evacuated tubes

Analysis and Simulation of the Effect of Dimensions on the Properties of Glass-Coated Magnetic Alloy Microwires

Structural transformation and rheological processes in bulk metallic glass Zr41Ti14Cu12.5Ni10Be22.5

Analysis on the thermal stress in the solid-state laser tube

Numerical Simulation of Residual Stress in the Glass-to-Metal Diffusion Seals

Analysis of Effect Factors on Residual Stresses Within Glass Tube to Kovar Alloy Brazed Joint

A Numerical Model to Reduce Thermal Residual Stress During Cooling and Annealing Process of Large Optical Glass Production

Numerical Simulation of Molten Pool Formation During Laser Transmission Welding Between PET and SUS304

FEM Analysis of Glass Lens Molding Press

Thermal stress analysis and structural optimization of ladle nozzle based on finite element simulation

Analysis of Influence Parameters on Residual Stress in Glass-to-metal Vacuum Brazing Flat Joint

Effects of interface thermal resistance on surface morphology evolution in precision glass molding for microlens array.

SIMULATION OF TEMPERATURE FIELD IN FLOAT GLASS SPREAD PROCESS

Study on Numerical Simulation for Control of Winding Process of Thin Wall Spiral Tube

Numerical Analysis of the Temperature Field during Single-pass Two-layers Laser Additive Manufacturing of Fused Silica Glass

Thermal Modeling of Wafer Based Precision Glass Molding Process