Abstract:AbstractCurrently, and due to their unique properties, carbon nanotubes (CNTs) and graphene (GA) are used extensively as filler materials to improve the performance of glass fiber-reinforced epoxy (GFRE). These additives can act as self-catalysts during treatment of the end-of-life GFRE products thermally and their conversion into energy products. In order to investigate this phenomenon, this research aims to study the effect of CNTs and graphene additives on pyrolysis characteristics of GFRE using thermogravimetry (TGA). The measurements were conducted on two different batches: CNTs/GFRE and GA/GFRE with filler concentration 0.04 wt.% and a batch fabricated using a vacuum-assisted resin transfer method. Also, the chemical compounds formulated during the decomposition process were analyzed using TG-FTIR and GC–MS system. In addition, the pyrolysis kinetics of both batches were simulated using linear isoconversional approaches (KAS, FWO, and Friedman) and nonlinear isoconversional approaches (Vyazovkin and Cai). Finally, the thermogravimetric analysis curves (TGA and DTG) were predicted using the distributed activation energy (DAEM) and the independent parallel reaction (IPR) models with a very small deviation. The ultimate and proximate measurement showed that both batches contained numerous volatile compounds (64%) and carbon element (30%). Meanwhile, TG measurements showed that the main composition zone was located in the range of 300–465 °C with weight loss of 38–40%. Aromatic benzene was the main function group in TG-FTIR result. Meanwhile, phenol, p-isopropenylphenol, phosphine oxide, and boron were the major compounds resulting from the GC–MS measurements. On the other hand, the pyrolysis kinetic analysis showed that the activation energies were estimated at 162–190 kJ/mol (linear isoconversional) and 171–177 kJ/mol (nonlinear isoconversional) with R2 estimated at 98–99%. Based on that, the CNTs and graphene added to GFRE composites act as self-catalysts, hence contributing to improvement in the quantity of the obtained volatile compounds, and their composition affected significantly by the applied heating conditions.

Thermal Decomposition Kinetics of Natural Fibers: Activation Energy with Dynamic Thermogravimetric Analysis

Thermal Decomposition Kinetics of Basalt Fiber-Reinforced Wood Polymer Composites

Kinetics of Bamboo Pyrolysis

Thermogravimetric Analysis and Activation Energy Calculation of Carbon Fiber Composite Cores

A Kinetic Study of the Thermal Degradation of Nylon-6/Attapulgite Nanocomposites

Thermal analysis and kinetic study of native silks

Kinetics Study of PVA Polymer by Model-Free and Model-Fitting Methods Using TGA

Thermal degradation of typical plastics under high heating rate conditions by TG-FTIR: Pyrolysis behaviors and kinetic analysis

KINETIC STUDY OF PINE SAWDUST PYROLYSIS VIA TG/DTG ANALYSIS

Mechanism Identification and Kinetics Analysis of Thermal Degradation for Carbon Fiber/Epoxy Resin

Pyrolysis kinetics of tannin–phenol–formaldehyde resin by non-isothermal thermogravimetric analysis

Thermal Analysis and Thermal Decomposition Kinetics of Polyester

Thermal Behavior and Kinetic Analysis of Enzymatic Hydrolysis Lignin and High-Density Polyethylene during Co-Pyrolysis

Thermogravimetric Analysis and Pyrolysis Kinetics of Tannery Wastes in an Inert Atmosphere

Thermal degradation mechanisms of wood under inert and oxidative environments using DAEM methods

Thermal decomposition of CNTs and graphene-reinforced glass fibers/epoxy and their kinetics

Nonisothermal decomposition kinetics of nylon 1010/POSS composites

Decomposition Kinetics and Lifetime Estimation of Thermoplastic Composite Materials Reinforced with rCFRP

Comprehensive study of thermal degradation behavior of carbon fiber flexible sucker rods: Product characteristics, kinetics and thermodynamics

Kinetics And Mechanism Of Thermal Decomposition Of Cornstarches With Different Amylose/Amylopectin Ratios

Determination of kinetic parameters during the thermal decomposition of epoxy/carbon fiber composite material