Abstract:Magnesium and its alloys have become increasingly attractive in the automotive, 3C products and aerospace industries because of their advantages such as low density and high specific strength. In recent years, rare earth-Mg alloys have attracted much attention due to their high mechanical properties at room and elevated temperatures. Adjusting the microstructures by deformation treatment is a common method to improve the mechanical properties of Mg alloys. The microstructure especially the size, volume fraction and distribution of second phases in rare earth-Mg alloys will be changed during deformation treatment, which has a great effect on the corrosion resistance of Mg alloys. However, the studies on the effect of deformation treatment on the corrosion resistance of rare earth-Mg alloys are far away from sufficient. In this work, the corrosion behavior of cast and forged Mg-5Y-7Gd-1Nd-0.5Zr ( EW75) alloys were studied by using SEM, XRD, mass loss measurements and electrochemical tests. The results indicate that the second phases are distributed along the grain boundaries of cast and forged EW75 alloys. Meanwhile, the second phases in forged EW75 alloy are finer and lower volume fraction than that in cast EW75 alloy. The micro-galvanic corrosion of the forged EW75 alloy is weaker in comparison with the cast EW75 alloy owing to the smaller size and lower volume fraction of second phases as well more compact surface film, resulting in the better corrosion resistance.

Effect of Second Phases on the Corrosion Behaviour of Wrought Mg–Zn–Y–Zr Alloy

The Role of Second Phases in the Corrosion Behavior of Mg–5Zn Alloy

Effect of the second phases on corrosion behavior of the Mg-Al-Zn alloys

Influence of Specific Second Phases on Corrosion Behaviors of Mg-Zn-Gd-Zr Alloys

Role of second phases on the corrosion resistance of Mg-Nd-Zr alloys

The Effect of Secondary Phase on Corrosion Behaviors of the Titanium–zirconium–molybdenum Alloy

Study on the Synergistic Effect of Second Phases and Product Films to Significantly Improve the Corrosion Resistance of Mg- Gd-Y-Nd Alloy

Effects of Second Phases on the Formation Mechanism and Corrosion Resistance of Phosphate Conversion Film on AZ80 Mg Alloy

The Special Role of Anodic Second Phases in the Micro-galvanic Corrosion of EW75 Mg Alloy

Mechanical Properties and Yield Asymmetry of Mg-Y-Zn Alloys: Competitive Behavior of Second Phases

Investigation of Corrosion Behaviors of Mg–6Gd–3Y–0.4Zr Alloy in NaCl Aqueous Solutions

Effect of grain size and second phase on the corrosion behavior of MIG-welded Al–Mg–Si–Mn–Cr alloy

The Effect of Zn Concentration on the Corrosion Behavior of Mg–xZn Alloys

Effect of Microstructure on the Corrosion Behavior of as-cast and Extruded Mg–Sn–Y Alloys

Corrosion Behavior of Mg-Zn-Y-Zr Alloys in Nacl Solution

Quantifying of the Effects of Secondary Phases on Corrosion in Mg-RE Alloys by X-Ray Computed Tomography

Effects of temperature-induced variation of the second phase on the microstructure, texture and properties of Mg-RE-Zn alloys

Effect of the Morphology of Long-Period Stacking Ordered Phase on Mechanical Properties and Corrosion Behavior of Cast Mg-Zn-Y-Ti Alloy

Comparative Study on Corrosion Behavior of Cast and Forged Mg-5Y-7Gd-1Nd-0.5Zr Alloys

Influence of the Β-Phase Morphology on the Corrosion of the Mg Alloy AZ91

Effect of W-phase on the Mechanical Properties of As-Cast Mg–Zn–Y–Zr Alloys