Abstract:The thermite reaction between Al and CuO is well known and highly exothermic. For a conventional thermite mixture, the reaction is rate limited by a slow heterogeneous mass transfer at the metal and oxide interface. The relatively low reaction rate and ignition difficulty have restricted practical applications for this reaction. For newly developed nanocomposed thermites, the interface area is substantially increased resulting in a much higher reaction rate and a new range of possible applications. A top-down approach to preparation of reactive nanocomposite materials in the Al-rich Al-CuO system is discussed in this paper. The materials are prepared using arrested reactive milling, a technique based on high-energy ball milling performed at room temperature and stopped (or arrested) before the exothermic reaction between Al and CuO is triggered mechanically. The products are micron-sized, fully dense powders in which reactive components are uniformly mixed on the nanoscale. Optimized milling conditions for the powders with bulk compositions xAl + 3CuO with x = 8, 10, and 12 are found. Respective powders are produced and characterized. Particle sizes are measured and the sizes of nano-inclusions of CuO in Al matrix are determined. Reactions occurring in the nanocomposite materials are also characterized by thermal analysis. Ignition of the produced powders is studied by coating them onto an electrically heated filament. Constant volume explosion experiments are used to characterize combustion performance of the produced powders. Compositions of the produced powders and products of their combustion are studied by X-ray powder diffraction. Correlations between combustion performance and material characteristics are established. Ignition for Al-rich Al-CuO nanocomposite powders was observed to occur at 850±10 K independently of the heating rate.

Synthesis of Fe2O3/Al Nanocomposite and Research on Its Thermite Reaction

Mechanism for thermite reactions of aluminum/iron-oxide nanocomposites based on residue analysis

Preparation and characterization of modified Al/Fe2O3 nano-thermite composite system

Enhanced energy performance from core–shell structured Al@Fe2O3 nanothermite fabricated by atomic layer deposition

Effect of Fe2O3 as an accelerator on the reaction mechanism of Al–TiO2 nanothermite system

Preparation of Core-Shell Ni (cu, Co)/Al Micron-Nano Composites and Characteristics of Thermite Reactions with Fe2o3

Synthesis Of Nano-Nickel-Coated Micro-Aluminum And Thermal Reactivity Of Aluminum/Nickel-Stannic-Oxide Thermite

THERMAL REACTIVITY OF AL/FE CORE−SHELL NANOCOMPOSITES

Study on combustion characteristics and pyrotechnic cutting effects of bimetal thermite Ni/Al/Fe2O3 system

Synthesis and phase formation mechanism of alpha-Fe2O3 powders by hydrothermal reaction method

Preparation of Fe_2O_3/Al Nanocomposite by Sol-gel Method

Preparation and Reactive Performances of Al/Co3O4/CoF2 Metastable Intermolecular Composites

Iron Oxide/Aluminum/Graphene Energetic Nanocomposites Synthesized by Atomic Layer Deposition: Enhanced Energy Release and Reduced Electrostatic Ignition Hazard

Fabrication and characterization of Al–CuO nanocomposites prepared by sol-gel method

Preparation and Reactive Performances of Al/Co 3 O 4 /cof 2 Metastable Intermolecular Composites

Thermite reactions of Al/Cu core-shell nanocomposites with WO3

Analysis of the Aluminothermic Reaction Process

Fully Dense, Aluminum-Rich Al-Cuo Nanocomposite Powders for Energetic Formulations

Thermal performance of Cu/Al micron-nanometer composites with tungsten trioxide

Thermal Reactivity of Nanostructure Al0.8mg0.2 Alloy Powder Used in Thermites

Electrophoretic Deposition and Characterization of Highly Exothermic Al/CuO Nanothermites