Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Effect of Bowed and Swept Rotors on Wake Transportation in a Transonic Compressor

NUMERICAL INVESTIGATION OF STATOR CLOCKING EFFECTS ON THE DOWNSTREAM STATOR IN A 1.5-STAGE AXIAL TURBINE

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Numerical Investigation of the Superimposed Effects on Stator Wake Oscillation in an Axial-Radial Combined Compressor

Stator wake variability in a combined compressor

Effects of Circumferentially Non-Uniform Clearance on the Spanwise Flow Characteristics in a Transonic Compressor Rotor

Numerical study of wake and potential interactions in a two-stage centrifugal refrigeration compressor

On the Stability of Transonic Compressor with Wet Compression and Blade Tip Water Injection

Unsteady near-stall flow mechanisms in a transonic compressor rotor at different rotating speeds

Numerical investigation of the unsteady tip leakage flow and rotating stall inception in a transonic compressor

Unsteady Pressure Behavior on Blade Surface Induced by Wake-Blade Interaction in an Axial Compressor Stage

Unsteadiness of Tip Leakage Flow in the Detached-Eddy Simulation on a Transonic Rotor with Vortex Breakdown Phenomenon

Impact of Wake on Downstream Adjacent Rotor in Low-Speed Axial Compressor

Numerical Simulation on Unsteady Flow Mechanism of a 1.5-Stage Axial Transonic Compressor

Numerical Investigation on the Originating Mechanism of Unsteadiness in Tip Leakage Flow for a Transonic Fan Rotor

Passage shock wave/boundary layer interaction control for transonic compressors using bumps

Investigation on the Interaction of Tip Leakage Flow/ Shock Wave/ Boundary Layer in a Transonic Compressor Stage

Numerical Investigation of the Turbulent Wake-Boundary Interaction in a Translational Cascade of Airfoils and Flat Plate

Numerical investigation of the unsteady flow and wave dynamics in a wave rotor combustor

Experimental and computational investigation on flow characteristics of rotating cavities with high inlet pre-swirl axial throughflow

High-Fidelity Simulation Study of the Unsteady Flow Effects on High-Pressure Turbine Blade Performance