Abstract:In this paper, the synthesis of poly(3,4-ethylenedioxythiophene) (PEDOT) by cyclic voltammetry (CV) electrochemical deposition and its application in the counter electrode of solid-state dye-sensitized solar cells were studied. The influence of cycle times (10 similar to 50 times) on the morphology, thickness and optical properties of PEDOT films were explored by Fourier transform infrared spectroscopy (FTIR), atomic force microscope (AFM), scanning electron microscope (SEM) and ultraviolet-visible spectroscopy (UV-Vis). The photoelectrochemical properties of solid-state dye-sensitized solar cells based on PEDOT transparent counter electrode were characterized by J-V, electrochemical impedance spectroscopy (EIS), intensity modulated photocurrent spectrum/photovoltage spectrum (IMPSNS) and Tafel analysis. The results showed that an un-uniform film with the thickness of 0.5 mu m and light transmittance of 80% was formed when CV cycle times was 10, where the PEDOT film was not completely covered on the substrate. When the CV cycles reached 30 similar to 40, a uniform and dense transparent film was obtained and the highest photo-electric conversion efficiency of the corresponding solid-state dye-sensitized solar cells reached 5.34%. This is because uniform and dense surface, good optical properties and high photo- electric catalysis properties (J(0) =2.51 X 10(-3) A.cm(-2)) for I-3 in the electrolyte, made the device obtain larger diffusion coefficient (D-n=28.80 mu m(2).ms(-1)) and carrier diffusion length (L = 21 .41 mu m), which were favorable for charge transfer. When the number of CV cycles was further increased to 50 times, showing greater roughness, the PEDOT fihn was no longer growing uniformly. The PEDOT film deposited on the FTO surface underwent some dissolution and desorption, the PEDOT film became uneven, and the catalytic activity of PEDOT electrode to I-3(-) in electrolyte was reduced. The device with PEDOT transparent counter electrode fihn deposited by cyclic voltammetry could also achieve double-side illumination with good catalytic activity to the electrolyte. Under the condition of double-side illumination, the photoelectric performance of the device using electrodeposited PEDOT as transparent counter electrode was improved by about 20%. The improvement of the photoelectric performance of the device is mainly due to the increase in the absorption of photons by the double-sided illumination.

[Enhanced V(oc) in Photovoltaic Cell by Electrodeposited Polythiophene Thin Film].

Photovoltaic Devices Based on a Novel Poly(phenylene Ethynylene) Derivative

High Performance Solar Cell Based on Ultra-Thin Poly(3-Hexylthiophene): Fullerene Film Without Thermal and Solvent Annealing

Synthesis and Photovoltaic Properties of Ester Group Functionalized Polythiophene Derivatives

Toward High Efficiency Organic Photovoltaic Devices With Enhanced Thermal Stability Utilizing P3ht-B-P3pht Block Copolymer Additives

Enhanced open-circuit voltage of two side chain conjugated polythiophene derivatives blended with indene-C60 bisadduct

Synthesis, Characterization, and Photovoltaic Property of a Low Band Gap Polymer Alternating Dithienopyrrole and Thienopyrroledione Units

Hydrophilic Poly(triphenylamines) with Phosphonate Groups on the Side Chains: Synthesis and Photovoltaic Applications

Polythiophenes with carboxylate side chains and vinylene linkers in main chain for polymer solar cells

Fine Tuning the HOMO Energy Levels of Polythieno[3,4-B]thiophene Derivatives by Incorporation of Thiophene-3,4-dicarboxylate Moiety for Photovoltaic Applications

Cu(I) Chelated Poly-Alkoxythiophene Enhancing Photovoltaic Device Composed of a P3HT/PCBM Heterojunction System

Synthesis, molecular structure and photovoltaic performance for polythiophenes with β-carboxylate side chains

Efficient conventional- and inverted-type photovoltaic cells using a planar alternating polythiophene copolymer

Simultaneously Enhancing the Dielectric Constant, Photo-Response and Deepening HOMO Levels of Benzo[1,2-B;4,5-b']dithiophene Derivatives-Based Conjugated Polymers

Conductivity Enhancement of PEDOT:PSS Film Via Sulfonic Acid Modification: Application As Transparent Electrode for ITO-free Polymer Solar Cells

Investigation of photovoltaic properties of poly(3-hexylthiophene): Polynaphthalene-bithiophene heterostructure devices

Simultaneously Enhancing the Efficiency and Stability of Perovskite Solar Cells by Using P3HT/PEDOT:PSS as a Double Hole Transport Layer

Electrochemical Synthesis of PEDOT and Its Application in Solid-State Dye-sensitized Solar Cells

Efficient Organic Photovoltaic Cells Using 2-(4-biphenylyl)-5-phenyl-1,3,4-oxadiazole As an Exciton Blocking Layer

Enhancement of the power conversion efficiency by expanding the absorption spectrum with fluorescence layers.

A polythiophene derivative with octyl diphenylamine-vinylene side chains: synthesis and its applications in field-effect transistors and solar cells