Abstract:Previous studies suggested that Zintl phases related to the Ca9Zn4.5− δ Sb9 (0 δ x Cu x Sb9 indicated that they could achieve an optimized zT around 0.7. Especially for Ca9Zn4.5− δ Sb9, a very recent report suggested that a high zT of 1.1 at 875 K could be obtained in combination of various secondary phases introduced by the variation of Zn contents, which provided a chemical potential to change the composition. However, to change the composition of Ca9Zn4.5− δ Sb9 is actually very difficult to implement owing to the narrow homogeneity range. In this work, with Ca substituted by big cations such as Eu2+ and Sr2+, the unit cell of Ca9Zn4.5− δ Sb9 was expanded, and similar significant enhancement on the thermoelectric performance was resulted. All syntheses were handled inside a glovebox, then the reactants were loaded in the Nb tube and arc-welded, which were enclosed in a fused silica tube. The reactions were firstly heated to 1173 K in 6 h and then maintained at this temperature for 24 h. After the homogeneity process, the furnace was slowly cooled down to 873 K at a rate of 6 K/h, followed by another dwelling for 6 hours and finally cooled down to 573 K at a rate of 10 K/h. At last, the furnace was shut down and the reactions were opened in the glovebox. The compound were fully characterized by single-crystal X-ray diffraction (SXRD) and powder X-ray diffraction(PXRD), Energy dispersive spectrometer (EDS) and Hall effect measurement, etc. Single-crystal X-ray diffraction (SXRD) proves that with the increase of Sr component, the crystal parameters are slightly increasing. Hall effect measurement show that the substitution of Ca by Eu or Sr can both lead to an obvious decreasing on the carrier (holes) concentration, and the resultant mobility for Sr/Eu-doped materials is very similar if compared by the same doping level. It is also noted that neither the carrier concentration nor the mobility seems to vary linearly with the Eu/Sr-doping contents, which means a saturated state will be eventually approached. This phenomenon is consistent with the speculation above that the changes on the properties should predominantly originate from the change of interstitial Zn content, which the size effect dominated. While the decreasing carrier concentrations as well as the increasing mobility and lattice thermal conductivity all point to a structure modification, the crystal structures of these doped materials were systematically verified through the single crystal X-ray diffraction. In conclusion, although a direct measurement on such a small composition variation is very difficult (the X-ray diffraction results prove it), the significantly reduced carrier concentration and increased mobility as well as lattice thermal conductivity can still provide some useful hints on understanding the property optimization of these materials. For material Ca8.2Eu0.8Zn4.5− δ Sb9, high figure of merit with ZT ~0.81 has been achieved at 873 K.

Synthesis and Properties of CaCd2Sb2 and EuCd2Sb2

Thermoelectric Properties of Yb(x)Eu(1-x)Cd2Sb2.

Band convergence and phonon engineering to optimize the thermoelectric performance of CaCd<sub>2</sub>Sb<sub>2</sub>

Regulating thermoelectric properties of Eu0.5Ca0.5Zn2Sb2 through Mg dopant

Band convergence and phonon engineering to optimize the thermoelectric performance of CaCd 2 Sb 2

Thermoelectric Properties of Non-Stoichiometric Cu2+xSn1-xS3 Compounds

The Transport and Thermoelectric Properties of Cd Doped Compounds (Cdxti1−x)1+ys2

Nanostructured Bi2-Xcuxs3 Bulk Materials With Enhanced Thermoelectric Performance

Ultralow Thermal Conductivity and Enhanced Figure of Merit for CuSbSe 2 via Cd-Doping

Sr/Eu Cation Doping and Thermoelectric Properties of the Compound Ca9Zn4.5−δSb9 (0<Δ<0.5)

Anisotropic thermoelectric properties of EuCd$_{2}$As$_{2}$ : An Ab-initio study

High‐Performance CaMg2Bi2‐Based Thermoelectric Materials Driven by Lattice Softening and Orbital Alignment via Cadmium Doping

Properties of single crystalline AZn2Sb2 (A=Ca,Eu,Yb)

Zintl-phase Eu2ZnSb2: A promising thermoelectric material with ultralow thermal conductivity

Tetragonal Kondo Insulator EuCd2Sb2 Discovered via High Pressure High Temperature Synthesis

Entropy-driven structural transition from tetragonal to cubic phase: High thermoelectric performance of CuCdInSe 3 compound

Improved Thermoelectric Performance of Cu12Sb4S13 Through Gd-Substitution Induced Enhancement of Electronic Density of States and Phonon Scattering.

Extremely Low Thermal Conductivity And High Thermoelectric Performance In Liquid-Like Cu2se1-Xsx Polymorphic Materials

Properties Of Single Crystalline Azn(2)Sb(2) (A = Ca,Eu,Yb)

Zintl-phase Eu 2 ZnSb 2 : A Promising Thermoelectric Material with Ultralow Thermal Conductivity

Unlocking the Potential of Cu3SbSe3: Ultralow Thermal Conductivity and Enhanced Thermoelectric Performance