Design, fabrication, and evaluation of high frequency, single-element transducers incorporating different materials
Kevin A. Snook,Jian-Zhong Zhao,Carlos H. F. Alves,Jonathan M. Cannata,Wo-Hsing Chen,Richard J. Meyer,Timothy A. Ritter,K. Kirk Shung,K.A. Snook,C.H.F. Alves,J.M. Cannata,R.J. Meyer,T.A. Ritter,K.K. Shung
DOI: https://doi.org/10.1109/58.985701
2002-02-01
Abstract:The performance of high frequency, single-element transducers depends greatly on the mechanical and electrical properties of the piezoelectric materials used. This study compares the design and performance of transducers incorporating different materials. The materials investigated include 1-3 lead zirconate titanate (PZT) fiber composite, lead titanate (PbTiO3) ceramic, poly(vinylidene fluoride) (PVDF) film, and lithium niobate (LiNbO3) single crystal. All transducers were constructed with a 3-mm aperture size and an f-number between 2 and 3. Backing and matching materials were selected based on design goals and fabrication limitations. A simplified coaxial cable tuning method was employed to match the transducer impedance to 50 ohms for the PZT fiber composite and PbTiO3 ceramic transducers. Transducers were tested for two-way loss and -6 dB bandwidth using the pulse/echo response from a flat quartz target. Two-way loss varied from 21 to 46 dB, and bandwidths measured were in the range from 47 to 118%. In vitro ultrasonic backscatter microscope (UBM) images of an excised human eye were obtained for each device and used to compare imaging performance. Both press-focusing and application of a lens proved to be useful beam focusing methods for high frequency. Under equal gain schemes, the LiNbO3 and PbTiO3 transducers provided better image contrast than the other materials.
engineering, electrical & electronic,acoustics