Third-generation superoxide anion sensor based on superoxide dismutase directly immobilized by sol-gel thin film on gold electrode.

Junwei Di,Shuping Bi,Ming Zhang
DOI: https://doi.org/10.1016/j.bios.2003.12.006
IF: 12.545
2004-01-01
Biosensors and Bioelectronics
Abstract:A third-generation biosensor for superoxide anion (O2−) was developed based on superoxide dismutase (SOD) immobilized by thin silica–PVA sol–gel film on gold electrode surface. A rapid and direct electron transfer of SOD in the thin sol–gel film at the gold electrode was realized without any mediators or promoters. The characterization of the SOD electrodes showed a quasi-reversible electrochemical redox behavior with a formal potential of 80+5mV (versus SCE) in 50mmoll−1 phosphate buffer solution (PBS), pH 7.0. The heterogeneous electron transfer rate constant was evaluated to be about 2.1s−1. The anodic and cathodic transfer coefficients are 0.6 and 0.4, respectively. Based on biomolecular recognition for specific reactivity of SOD toward O2−, the SOD electrode was applied to a sensitive and selective measurement of O2− with the low operation potential (−0.15V versus SCE) in phosphate buffer solution, pH 7.0. The amperometric response was proportional to O2− concentration in the range of 0.2–1.6μmoll−1 and the detection limit was 0.1μmoll−1 at a signal-to-noise ration of 3. The preparation of SOD electrode is easy and simple. The uniform porous structure of the silica–PVA sol–gel matrix results in a fast response rate of immobilized SOD and is very efficient for stabilizing the enzyme activity.
What problem does this paper attempt to address?