Atomization Characteristics of Swirling Steam-based Mechanical Oil Sprayers for a Supercharged Marine Boiler

王建志,王永堂,吴少华,秦裕琨

DOI: https://doi.org/10.3969/j.issn.1001-2060.2007.03.018

2007-01-01

Abstract:By using a LPI-3 diffraction type caliper gage of laser particles and a LE-3 atomizing-angle measuring device an experimental study has been conducted of the above-mentioned oil sprayer for marine use. Identified was the variation relationship between the Sauter mean diameter of atomized oil droplets and sprayed oil quantity on the one hand and its oil pressure on the other. By utilizing the Realizable k-e model, the turbulent gas flow was simulated followed by a simulation of the droplet movement by using a random orbit model. The deformation and fragmentation of droplets were also simulated by employing the LISA and TAB models. A numerical simulation was performed of the atomization process of the above-mentioned oil sprayer along with an analysis of the effect of the atomized air and oil mass flow rate in the oil sprayer on the atomization characteristics. The simulation results are in comparatively good agreement with the test ones. The research indicates that when the oil spray pressure is above 1.1 MPa, the oil sprayer characteristics comply with the general law of mechanical atomizing nozzles. But when the oil spray pressure is relatively low, the atomization mechanism will take a reverse course, i.e. the lower the oil spray pressure, the finer the atomized particles. From the foregoing it can be shown that the swirling steam-based mechanical atomized-oil sprayer can maximally improve the atomization quality under a low-load operating condition and has a relatively large turndown ratio with a steam consumption rate lower than that of an often-used pneumatic atomized-oil sprayer.