Abstract:Cold gas spray is a relatively new coating technique by which coatings can be formed without significant heating of the sprayed powder. In contrast to the conventional thermal spray processes, such as flame, arc, and plasma spraying, in cold spraying there is no melting of particles prior to impact on the substrate. In cold spray, particles are accelerated to a very high velocity by a flowing gas with supersonic speed and the temperature of spray particles is much lower than its melting point. However, being accomplished in so short an interval, the impact and deposition processes are difficult to be observed by experimental ways. Using molecular dynamics simulation, the deposition of nano-scale Au clusters on Au (001) surface was studied. The many-body potential is used to simulate the interatomic force between the atoms. By taking “snapshot”, the impact, deposition process and the final appearances of the cluster and the substrate were observed directly. It is found that both the substrate and the cluster deform and lose the crystalline structure. But after reconstruction and relaxation, both of them recover the crystalline structure. By calculating the temperatures of the substrate and the local area influenced by impinging, it is found that the melt phenomenon occurs during impact and deposition, whereas the temperature of the rest region of the substrate is still below the melt point. In addition, the influence factors on deposition, such as incident velocity and the size of the cluster, are discussed in the paper. Simulation results show that the higher incident velocity or the larger size of the cluster could result in stronger interaction between the substrate and the cluster owing to the higher kinetic energy of the cluster.

Simulations on nanotribological properties of molecular deposition films

Molecular Dynamics Simulation on Nanotribological Properties of Molecular Deposition Film During the Scan Process

Computer Simulations on Mechanical Properties of Molecular Deposition Film

Nano-tribology Through Molecular Dynamics Simulations

Nanomechanical Properties of Molecular Deposition Film

Molecular Dynamics Simulation of Molecular Deposition Film Subject to Nano-indentation Test

Molecular dynamics simulation of Au nano-scale particle deposited on Au surface during cold spraying

Experimental and Molecular Dynamics Investigation on Tribological Properties of Nanocrystalline Diamond Films.

Influence of Nanoparticles in Lubricant on Sliding Contact of Atomic Rough Surfaces—A Molecular Dynamics Study

Molecular Dynamics Simulation of Energetic Atom Depositions of Au/Au(100) Film

Molecular Dynamics Study Of Nano-Tribological Properties Of Silicon Nitride Films

Molecular Dynamics Simulation of the Effect of Nanoparticles on the Tribological Properties of Lubricant Film

Molecular dynamics simulations of atomic-scale tribology between amorphous DLC and Si-DLC films

Molecular simulations of sliding process between Fe and DLC films on various boundary conditions

Preparation, Characterization and Investigation of Molecular Films Coated on Diamond-Like Carbon Substrate

Molecular Dynamics Simulation of Au Cluster Depositing on Au Surface in Cold Gas Spray

Molecular Ordered Films and Their Research Progress on Tribological Behavior

Molecular Dynamics Simulation of the Structure and Friction Properties of Thin Film Lubrication

Advances in Studies on Tribological Properties of Ordered Molecular Films

Theoretical investigation about secondary deposition of thin-film formation by molecular dynamics simulation

Molecular Dynamics Study of Interfacial Slip Behavior of Ultrathin Lubricating Films