Abstract:Using mineral powder, fly ash and cement as the basic three-component composite system, machine-made sand and gravel powder and expansion agent are introduced to prepare five-component composite grouting materials. The water-binder ratio, stone powder content, the water glass modulus, the alkali content, the water-cement ratio, and machine-made sand and gravel powder content were studied for the physical and mechanical properties of alkali-activated multi-component composite grouting materials. The law of influencing factors and the optimal parameters of each factor were determined according to fluidity, setting time, compressive strength, and drying shrinkage. The optimal values of water glass modulus and alkali content are 1.0 and 6%, respectively. Increasing the water-binder ratio significantly improves fluidity, but results in a substantial delay in setting time and a decrease in strength. Therefore, it is not advisable to exceed a water-binder ratio of 0.6. Furthermore, the stone powder content should not surpass 10%. The hydration process of alkali-activated materials mainly includes crystallization nucleation and growth, phase boundary reaction and diffusion. Three types of expansion agents, CaO, MgO and SC (the mixture of calcium sulfoaluminate and calcium oxide), were selected, and four levels of 0%, 4%, 8%, and 12% were set, including a total of 9 mix ratios besides the benchmark group. The effects of expansion agents on the fluidity setting time, compressive strength and volume stability of composite grouting materials were discussed. The addition of an expansion agent proves effective in reducing drying shrinkage, with the sequence of effectiveness as follows: CaO expansion agent > MgO expansion agent > SC expansion agent. The optimal content of CaO expansion agent is found to be 8%, leading to a remarkable reduction in 28 d shrinkage.

Research on preparation and properties of inorganic cementitious desert greening bricks

Research On Preparation And Properties Of Inorganic Gelling Materials For Sand Fixation

EVALUATION OF THE ORGANOSILICON MATERIALS FOR ANCIENT GREY BRICKS PRESERVATION

Preparation of Sintered Brick with Aluminum Dross and Optimization of Process Parameters

Preparation of Porous Chemical Sand-fixing Brick

Utilization of Sandy Soil as the Primary Raw Material in Production of Unfired Bricks

Mechanism of Strength Formation of Unfired Bricks Composed of Aeolian Sand–Loess Composite

Experimental Study on Mechanical Properties of Soft Clay Stabilized by Industrial By-Products

Research on the performance of sand-based environmental-friendly water permeable bricks

Preparation process and performance study of desert sand autoclaved bricks

Preparation and Mechanism of the Sintered Bricks Produced from Yellow River Silt and Red Mud.

Study on Preparation of Bricks with Volcanic Rock and Its Performances

Study on the performance and reaction mechanism of alkali-activated clay brick with steel slag and fly ash

Study on Preparation of Decarburized Fly Ash-phosphogypsum Autoclaved Brick

Optimization and mechanism analysis of a compound additive for unfired bricks made of construction and demolition wastes

Optimization design and mechanical properties of multi-component ecological gelling materials

Study on the properties of innovative green brick subjected to varying temperature and time

Preparation, characteristics and mechanisms of the composite sintered bricks produced from shale, sewage sludge, coal gangue powder and iron ore tailings

Fabrication of Lead–Zinc Tailings Sintered Brick and Its Effect Factors Based on an Orthogonal Experiment

Green-brick preparation method for the resource utilization of sewage sludge and phosphogypsum with a low heavy-metal pollution risk

Development and Evaluation of Physical and Mechanical Properties of Alkali-Activated Multi-Component Composite Grouting Materials