Abstract:High-strength low-alloy steels are widely used, but their traditional heat-treatment process is complex, energy-intensive, and makes it difficult to fully exploit the material's potential. In this paper, the electropulsing processing technology was applied to the quenching and tempering process of ZG25SiMn2CrB steel. Through microstructural characterization and mechanical property testing, the influence of electropulsing on the solid-state phase transition process of annealing steel was systematically studied. The heating process of the specimen with the annealing state (initial state) is the diffusion-type transition. As the discharge time increased, the microstructure gradually transformed from ferrite/pearlitic to slate martensite. Optimal mechanical properties and fine microstructure were achieved after quenching at 500 ms. The steel subjected to rapid tempering with 160 ms electropulsing exhibited good, comprehensive mechanical properties (tensile strength 1609 MPa, yield strength 1401.27 MPa, elongation 11.63%, and hardness 48.68 HRC). These favorable mechanical properties are attributed to the coupled impact of thermal and non-thermal effects induced by high-density pulse current. Specifically, the thermal effect provides the thermodynamic conditions for phase transformation, while the non-thermal effect reduces the nucleation barrier of austenite, which increases the nucleation rate during instantaneous heating, and the following rapid cooling suppresses the growth of austenite grains. Additionally, the fine microstructure prevents the occurrence of temper brittleness.

Effect of Electropulsing on Recrystallization and Mechanical Properties of Silicon Steel Strips

Effect of Electropulsing on Recrystallization of Fe-3%Si Alloy Strip

Electropulsing Induced Texture Evolution in the Recrystallization of Fe-3 Pct Si Alloy Strip

OS0101 Effect of Electropulsing on Recovery of Strain in Stainless Steel

Effect of Electroplastic Treatment on Microstructure and Texture Changes of a Cold Rolling AZ31 Strip

Electropulsing-induced Phase Transformations and Their Effects on the Single Point Diamond Turning of a Tempered Alloy AZ91

Static Electropulsing-Induced Microstructural Changes and Their Effect on the Ultra-Precision Machining of Cold-Rolled AZ91 Alloy

Electropulsing-induced G-texture Evolution in a Deformed Fe–3%Si Alloy Strip

Effect of Electropulsing Treatment on the Microstructure and Superelasticity of TiNi Alloy

Mechanism of Electropulsing Induced Recrystallization in a Cold-Rolled Mg–9Al–1Zn Alloy

Effect of Electropulsing Treatment on the Mechanical Properties of Q235 Steel Strip

Effect of Electropulsing-Assisted Turning Process on AISI 5120 Cementation Steel

Effect of the electropulsing on microstructure and mechanical properties of the cold-drawing copper wire

Influence of Electropulsing Treatment on Microstructure and Mechanical Properties of Cold-Rolled Mg–9Al–1Zn Alloy Strip

Effect of Electropulsing on Surface Mechanical Properties and Microstructure of Aisi 304 Stainless Steel During Ultrasonic Surface Rolling Process

Strengthening and Toughening of ZG25SiMn2CrB Steel without Tempering Brittleness via Electropulsing Treatment

Effect of Electropulsing Assisted Cutting Process on Cutting Properties of Quenched GCr15 Bearing Steel

Application of High-Density Electropulsing to Improve the Performance of Metallic Materials: Mechanisms, Microstructure and Properties

Microstructure and texture evolution of the cold-rolled AZ91 magnesium alloy strip under electropulsing treatment

The effects of electropulsing on the recrystallization behavior of rolled pure tungsten

Effects of electropulsing on the glass transition and structural relaxation of a Cu60Zr28Ti12 metallic glass