Abstract:Silica aerogels generally exhibit poor mechanical properties, which seriously restrict their commercial use and makes it necessary to reinforce their structures to obtain materials strong enough to withstand mechanical stresses. The incorporation of polymers into silica aerogels is a promising approach due to the enhancement in mechanical strength afforded and the possibility of imparting the hydrophobicity of the polymers to the resulting aerogels. However, the processes typically employed to prepare polymer-reinforced silica aerogels are complex, arduous and costly, requiring multiple washing and soaking steps for the infiltration of the polymer precursors after gelation and supercritical drying. Additionally, diffusion problems can result in heterogeneity in aerogel monoliths due to the use of various cross-linked polymers and the autoclave-limited dimensions of aerogels. In this study, a facile sol–gel route was developed to fabricate a large (500 cm3) polymer–silica aerogel monolith that was stable under atmospheric conditions and suitable for machining. The synthesis of the polymer–silica aerogels began with a facile one-pot reaction involving resorcinol (R), formaldehyde (F), methyltrimethoxysilane (MTMS), and N-(β-aminoethyl)-γ-aminopropyl-trimethoxysilane (AEAPTES), followed by an ambient-pressure drying process. The resulting aerogels were characterised by nitrogen adsorption–desorption, scanning electron microscopy (SEM), contact angle, and thermal conductivity measurements, and the aerogel mechanical properties were evaluated by a unidirectional compression test. The Young's modulus of compression of the aerogels was observed to increase from 3.95 to 34.88 MPa with an increase in the density of the aerogels from 0.14 to 0.26 g cm−3. Simultaneously, the aerogels were observed to be superhydrophobic, with a contact angle as high as 168°, and exhibited low thermal conductivity (0.038 W m−1 K−1) and good absorption for organic liquids, which are critical characteristics for the practical application of aerogels, especially in energy-saving and oil-/chemical-cleanup practices.

Advances in Studies on Polymer Modified Silica Aerogels

Mechanical properties of polymer-modified silica aerogels dried under ambient pressure

Advances in multiple reinforcement strategies and applications for silica aerogel

The Synthesis and Polymer-Reinforced Mechanical Properties of SiO<sub>2</sub> Aerogels: A Review

Preparation and Characterization of Polymer Modified Silica Aerogels Dried under Ambient Pressure

The Synthesis and Polymer-Reinforced Mechanical Properties of SiO2 Aerogels: A Review

Advances in Polymer Aerogels

One-pot Synthesis of Polymer-Reinforced Silica Aerogels from High Internal Phase Emulsion Templates.

Ambient-pressure drying synthesis of large resorcinol–formaldehyde-reinforced silica aerogels with enhanced mechanical strength and superhydrophobicity

Research Progress on Modification of Aerogels by Chemical Vapor Deposition

Fabrication of Mechanically Strong Silica Aerogels with the Thermally Induced Phase Separation (TIPS) Method of Poly(methyl methacrylate)

Preparation of Silica Aerogels Via Ambient Pressure Drying

Isocyanate-crosslinked silica aerogel monolith with low thermal conductivity and much enhanced mechanical properties: Fabrication and analysis of forming mechanisms

Silica aerogel; synthesis, properties and characterization

Evolutionary Progress of Silica Aerogels and Their Classification Based on Composition: An Overview

Preparation and Thermo-Mechanical Properties of Modified Gelatin Reinforced SiO2 Aerogels

An Updated Overview of Silica Aerogel-Based Nanomaterials

Synthesis and Surface Strengthening Modification of Silica Aerogel from Fly Ash

Preparation of superhydrophobic and flexible polysiloxane aerogel

Recent advances and prospective of reinforced silica aerogel Nanocomposites and their applications

Silica aerogels with tailored chemical functionality