Abstract:This article proposes an approximate prediction method for slamming loads in parametric rolling condition for large container ships and the method has been validated through model experiments. Up to now, there have been some studies focused on two-dimensional asymmetric slamming analysis. Nevertheless, slamming load prediction in parametric rolling condition should consider not only heave and pitch motions, but also large amplitude roll motion which is usually neglected in analysis. For this purpose, a 6-DOF weakly nonlinear time domain model is adopted to predict the ship motions including parametric roll motion. The consequent roll motions obtained by the proposed model are incorporated in the calculation of impact angle and relative vertical velocity between ship section on the bow flare and wave surface, according to an asymmetric water entry assumption. Slamming impact loads and occurrence probability of slamming are analyzed by the Wagner model. To validate the numerical method, the segmented model experiment of a 10000 TEU container ship was executed and the slamming impact pressures and bending moments were measured for the wave condition and ship forward speed. The calculated pressures are compared with experiments. Based on numerical simulations, the maximum flare slamming pressures and slamming occurrence probability in different speed and wave conditions are investigated. The results indicate that flare slamming pressure is smaller than bottom slamming, but possessing longer lasting time and the occurrence of flare slamming is associated with the cycles of parametric rolling motions. Furthermore, the relationship between slamming pressure and 3-DOF motions namely roll, pitch and heave in the simultaneous simulation is given and the mechanism of flare slamming phenomena in parametric rolling condition is elaborated.

Research on Probabilistic Prediction Method of Ship Bottom Slamming

Calculation Method of Bottom Slamming Pressure Based on Randomness of Wave Surface

Probability Distribution of Ship Bottom Slamming Pressure Considering the Randomness of Wave Surface Slope

Numerical Prediction And Experimental Validation Of Slamming Load For Large Container Ship Undergoing Parametric Rolling Motion

The Effect of Speed and Sea State for Probability of Ships Slamming

CFD Prediction of Ship Seakeeping and Slamming Behaviors of a Trimaran in Oblique Regular Waves

Potential -Flow and CFD Investigations of Bow-Flare Slamming on a Container Ship in Regular Heading Waves

Numerical Study on the Dynamic Response of the Large Containership's Bow Structure under Slamming Pressures

On bottom slamming load and strength requirement for Structures of Box Barges

Experimental and Numerical Prediction of Slamming Impact Loads Considering Fluid–Structure Interactions

Approximation Method for Flare Slamming Analysis of Large Container Ships in Parametric Rolling Conditions

Numerical study of slamming and whipping loads in moderate and large regular waves for different forward speeds

Research on the bow-flared slamming load identification method of a large container ship

Experimental study of wet deck slamming for a SWATH in regular waves

Numerical investigation on the slamming loads of a truncated trimaran hull entering regular waves

Numerical simulation of 2-D bow flare slamming using SPH method

Numerical study for slamming loads on the bow of a ship-type FPSO model under breaking waves

Slamming of ships: where are we now?

Research on ship motion characteristics in a cross sea based on computational fluid dynamics and potential flow theory

Experimental and Numerical Investigation on Slamming Mechanism of a Mooring Column-Stabilised Semi-Submersible

Experimental study of slamming pressure for a trimaran section with different drop heights and heel angles