Abstract:Negative air gap and wave slamming load on the deck box of drilling semi-submersible units in severe storm have received a great deal of attention, due to the COSL Innovator accident in 2015. Equally important is vertical slamming load on the MODU underdeck, which is less reported in the literature. The present paper attempts to derive characteristic vertical slamming pressure on the deck bottom, based on an extensive model test program for a drilling semi-submersible unit, CM-SD1000. A total of 96 3-hour wave impact tests were conducted including 4 sea states selected along the DNV steepness criterion curve in 3 wave headings. Two critical sea states were identified and each was tested with 16 random realizations in both the head and the beam waves. 8 force panels were installed on the under-deck to capture vertical wave impact events. It is found that the peak slamming pressures obtained can be fitted well with both Weibull and Gumbel probability function. The extreme vertical impact pressure predicted are of the same order of magnitude as the extreme horizontal impact pressure. The present study also shows that rise velocities of the wave surface relative to the deck bottom have a remarkable correlation with the wave slamming pressure in terms of probability distribution. The relative rise velocities can be properly derived from wave probe measurements. This offers an alternative approach to estimate the vertical impact pressure without resort to force panels. In contrast to horizontal wave slamming, the magnitude and frequency of vertical ones simply increases with significant wave height and wave steepness has much less effect. It is found that the extreme vertical impact pressure can be approximated well by a linear function of the significant wave height. The linear relationship, if validated by more tests, may help evaluate structural strength of the deck bottom before wave basin model testing.

On bottom slamming load and strength requirement for Structures of Box Barges

Numerical Study on the Dynamic Response of the Large Containership's Bow Structure under Slamming Pressures

Experimental and Numerical Investigation on Slamming Mechanism of a Mooring Column-Stabilised Semi-Submersible

Potential -Flow and CFD Investigations of Bow-Flare Slamming on a Container Ship in Regular Heading Waves

Underdeck Wave Slamming Model Tests for a Drilling Semi-Submersible Unit

Ship Loading Influence on the Slamming Impact of Typical Sections of an S-175 Container Ship

Numerical Prediction And Experimental Validation Of Slamming Load For Large Container Ship Undergoing Parametric Rolling Motion

Numerical study for slamming loads on the bow of a ship-type FPSO model under breaking waves

Experimental and Numerical Prediction of Slamming Impact Loads Considering Fluid–Structure Interactions

Research on the bow-flared slamming load identification method of a large container ship

Dynamic Response Analysis of a Bulk Carrier by Nonlinear Hydroelastic Method

Calculation Method of Bottom Slamming Pressure Based on Randomness of Wave Surface

Research on Probabilistic Prediction Method of Ship Bottom Slamming

Investigation of Container Ship Structural Dynamic Ultimate Strength Under Combined Bending, Torsion and Lateral Pressure

Comparison on Rule Requirements of the ULCS Bowflare Slamming

Simulation of impact load on ship-platform collision

The Distribution of Slamming Pressure on Flat-Bottom Structure

Numerical study of slamming and whipping loads in moderate and large regular waves for different forward speeds

Experimental investigation on the slamming loads of a truncated 3D stern model entering into water

Numerical investigation on the slamming loads of a truncated trimaran hull entering regular waves

The Effect of Speed and Sea State for Probability of Ships Slamming