Abstract:This paper investigated numerically the application of Vortex Generator Jets (VGJs) to control flow separation on the suction side of a low pressure turbine blade. Firstly, numerical simulations of flow separation for a LPT blade, which based on Menter's SST k-omega turbulence model coupled with Langtry-Menter transition model, were performed for different Reynolds numbers Re similar to 100,000, 75,000, 50,000 and 25,000, for three freestream turbulence intensity (FSTI) of 0.08%, 2.35% and 6.0%. The pressure distributions around the turbine blade and streamline plots showing the flow separation were presented in this paper. Good agreement of the numerical and experimental results also showed the validity of the numerical scheme for simulating the flow separation occurring on a low pressure turbine blade. And then, steady Vortex Generator Jets (steady VGJs) having pitch angle of 30 degrees, skew angle of 90 degrees, blowing ratio of 2.0 were used to control the flow separation in the suction side of the low pressure turbine blade. Although steady VGJs have been illustrated to be extremely robust at suppressing low Reynolds number separation, the practical application of VGJs in the low pressure turbine engine is in the pulsed mode. The injection mass flow requirements of pulsed Vortex Generator Jets (pulsed VGJs) can be reduced drastically when similar flow control effect is obtained using steady VGJs. For pulsed VGJs, the pulse frequency has been found to be an important control parameter for the flow separation control. In this paper, cases with the duty cycle of 0.5 were studied for the pulse frequency ranging from 2.5Hz to 10Hz at Re=25,000 and freestream turbulence level of 0.08%. The numerical results showed that pulsed VGJs can effectively reduce and even eliminate the flow separation on the blade suction surface while there is an optimal pulse frequency. The flow control mechanism of VGJs on LPT blade was also revealed.

Large-eddy Simulation for Control of Flow Separation in Conical Diffuser by Vortex Generator Jets

Experimental and Numerical Study on Flow Separation Control in Rectangle Diffuser

Study on Flow Separation Control by Vortex Generator Jets with Different Parameters

Visualization of vortex generator jets for conical diffuser separation control using PIV

Steady and Pulsed Vortex Generator Jets Control of Flow Separation in Rectangle Diffuser

Numerical Study of Flow in Conical Diffuser with Vortex Generator Jets

CFD Simulation for Up Flow Jet-Loop Reactors by Use of Bi-Dispersed Bubble Model

Flow Separation Control in a Conical Diffuser with a Karman-vortex Generator

Unsteady Flow Control of a Plane Diffuser Based on a Karman-vortex Generator

A Karman-Vortex Generator for Passive Separation Control in a Conical Diffuser

Study on the Special Vortical Structure Development During Flow Separation Control by VGJs in Boundary Layer of Flat Plate with Adverse Pressure Gradient

Research on the Effect of Vortex Generators on Controlling Flow Separation of Hydrofoil

Numerical Investigations Of Flow Separation Control For A Low Pressure Turbine Blade Using Steady And Pulsed Vortex Generator Jets

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Hydrodynamic flow separation control through vortex generators

Numerical study on flow separation control of cascades with synthetic jet using dynamic mesh method

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

A flow separation control on cylinder flow

Large Eddy Simulation of Micro Vortex Generator-Controlled Cavitation Across Multiple Stages

Large-Eddy Simulation of Flow Separation Control in Low-Speed Diffuser Cascade with Splitter Blades

Study On Vortex Generators For Control Of Attached Cavitation