Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

A flow separation control on cylinder flow

Research on the Effect of Vortex Generators on Controlling Flow Separation of Hydrofoil

Study On Vortex Generators For Control Of Attached Cavitation

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Control Effect of Micro Vortex Generators on Leading Edge of Attached Cavitation

Large Eddy Simulation Investigation of Micro-Vortex Generator Control Effect on Early Stage Sheet Cavitation

Control Effect of Micro Vortex Generators on Attached Cavitation Instability

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Flow Separation Control in a Conical Diffuser with a Karman-vortex Generator

Effects of Lateral Space and Angle of Attack on Ventilated Partial Cavity

Study of Separation Control of Vortex Generators on Transonic Wings

Study of Control Effects of Vortex Generators on a Supercritical Wing

Large Eddy Simulation of Micro Vortex Generator-Controlled Cavitation Across Multiple Stages

Control of flow separation over a circular cylinder using synthetic jet

Numerical study on the flow control mechanisms of an off-surface circular cylinder for wall-bounded flows with separation

A Lagrangian Analysis of Partial Cavitation Growth and Cavitation Control Mechanism

Unsteady Flow Control of a Plane Diffuser Based on a Karman-vortex Generator

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Boundary layer analysis of ventilated partial cavity for friction drag reduction

A Karman-Vortex Generator for Passive Separation Control in a Conical Diffuser

Review of passive control of flow past a circular cylinder