Abstract:YBCO bulks with submicron Y2BaCuO5 particles have been prepared under oxygen partial pressures of 0.21atm and 1atm, respectively, by the powder melting process (PMP). The microstructures, oxygen contents and critical current densities of the samples have been investigated. The results showed that the sample grown under P(O2) = 1 atm contained Y2BaCuO5 particles with a little bigger average size and had a slightly higher density of stacking faults than the one prepared under P(O2) = 0.21 atm. Oxygen content measurements indicated that the as-grown sample under P(O2) = 1 atm had a higher oxygen content. After post-annealing in flowing oxygen, the oxygen content of the P(O2) = 1 atm sample was still higher than that of the P(O2) = 0.21 atm sample. They were examined to be 6.94 and 6.88 with X-ray diffraction for the two oxygenated samples, respectively. Magnetization measurements have been performed on the two types of oxygenated samples and critical current densities (Jc) have been calculated based on the extended Bean critical state model. The P(O2) = 0.21 atm sample exhibits Jc values of 5.47×105 A/cm2 and 2.22×104 A/cm2 in 1 T magnetic field at 20K and 77K, respectively. The P(O2) = 1 atm sample, meanwhile, has Jc values of 9.46×105 A/cm2 and 1.47×104 A/cm2 in 1 T magnetic field at 20K and 77K, respectively. Moreover, at 20K, the Jc of the P(O2) = 1 atm sample is higher than that of the P(O2) = 0.21 atm sample in an applied magnetic field up to 5 T. At 77K, however, the Jc of the P(O2) = 1 atm sample drops more quickly than that of the P(O2) = 0.21 atm sample. The mechanisms of the different microstructures, oxygen contents and magnetic field dependence behaviors of Jc for the two kinds of samples have been discussed.

The oxygen in- and out-diffusion behavior in melt-textured YBCO measured by thermogravimetry

Chemical diffusion of oxygen in crushed single-crystal YBa2Cu3O7−δ investigated by thermogravimetry

Oxygen In-Diffusion in LPE Thick Films of YBCO by Electrical Resistance Relaxation

Electrical Conductivity Relaxation Studies of Oxygen Transport in Epitaxial YBa/sub 2/cu/sub 3/o//sub 7-Γ/ Thin Films

In-Diffusion and Out-Diffusion of Oxygen in C-Axis-Oriented YBa_2Cu_3O_(6+x) Film, Studied by in Situ X-Ray Diffraction

In-Plane and Out-of-Plane Anisotropy in the Optical and Dielectric Properties of Yba2cu3o7-X Superconducting Film

Enhanced Growth Rate of a YBCO Bulk in the Melt-Textured Process under 1 Atm Oxygen Pressure

SIMS study of oxygen spiral diffusion in c-textured YBa<sub>2</sub>Cu<sub>3</sub>O<sub>7-δ</sub>/SrTiO<sub>3</sub>epitaxial thin film

Chemical Diffusion of Oxygen in a C-Axis-oriented YBa2Cu3O7-δ Film

Enhancement of Ybco Thin Film Thermal Stability under 1 Atm Oxygen Pressure by Intermediate Cu2o Nanolayer

Manometric Determination of the Oxygen Diffusion Coefficients in YBa2Cu3−yFeyO6+x

Sims study of oxygen spiral diffusion in c-textured YBa2Cu3O7-δ/SrTiO3 epitaxial thin film

X-ray diffraction study on YBa2Cu3O7-δ with BaCuO2 addition

Thermodynamics and Kinetics Analysis of Mod-Ybco Heat Treatment Process Using in Situ Resistance Measurement Method

Local strain-driven migration of oxygen vacancies to apical sites in YBa2Cu3O7-x

Influence of Oxygen Partial Pressure on the Microstructures and Critical Current Densities of PMP-Processed YBCO Bulks with Submicron Y2BaCuO5 Particles

X-Ray Diffraction Study On Yba2cu3o7-Delta With Bacuo2 Addition

Effects of Gd2O3 Addition in YBa2Cu3O7−δ on the Critical Current Density

In situ high temperature optical microscopy study of phase evolution in YBa 2 Cu 3 O 7 d films prepared by a fluorine-free sol – gel route

Kinetics study of ab-plane crack propagation by a modulus measurement in single domain YBa2Cu3Ox

Observation of the Tetragonal-Orthorhombic transition in polycrystalline YBa$_2$Cu$_3$O$_{6+δ}$ samples during the oxidation process at constant temperature via thermogravimetry and differential thermometry analysis