Abstract:Based on the continuum assumption and Navier-Stokes equation, three-dimensional fluid flow and conjugate heat transfer in heat sinks with rectangle microchannels have been studied by numerical simulation. The validation of this approach has been demonstrated by comparisons with analytical solutions. Results were obtained for the detailed description of the local and average heat transfer characteristics including wall and fluid temperatures, heat flux, Nusselt number (Nu). Effects of the Peclet number (Pe), the relative conductivity (kw/kf) and the relative thickness (W/D) of solid substrate were presented and discussed. At low Pe flow, axial conduction dominates the heat transfer, which results in a large upstream region which is pre-warmed by axial conduction, so axial conduction cannot be neglected at small Pe. The increase of Pe induces an enhancement of convection, the heat exchange mainly happens on heat region by convection under this condition. A more uniform streamwise temperature distribution at fluid-solid interface indicates the enhancement of the pre-warmed effect along with the increase of kw/kf. The study also reveals that the Nux of low kw/kf material is higher than the Nux of high kw/kf material. The increase of wall thickness has an effect on axial distribution of the Nux, the trend is similar to that of an increase of the wall thermal conductivity kw/kf. It was concluded that the average Nusselt number is proportional to thermal conductivity of the wall. For low Pe, the fluid is heated by the wall by means of convection on heat region, when Pe ≤ 1, a slight increase of the Nu on heat region is shown as the increase of Pe. When Pe > 10, the convection is the dominant factor in heat transfer, an obvious increase of Nu is shown with increase of Pe. For high Pe flow, the heat transfer enhancement as increase of Pe is weak.

An Experimental and Numerical Study of Forced Convection in A Microchannel with Negligible Axial Heat Conduction

A numerical study of laminar convective heat transfer in microchannel with non-circular cross-section☆

Heat Transfer for Laminar Slip Flow in a Microchannel of Arbitrary Cross Section with Complex Thermal Boundary Conditions

Experimental Study on Flow and Heat Transfer Characteristics in Rectangular Microchannel

Investigation Of Flow And Heat Transfer Characteristics In Rectangular Small/Microchannels

Experimental and numerical study of flow and heat transfer in trapezoidal microchannels

Effect of Axial Conduction on Heat Transfer in a Rectangular Microchannel with Local Heat Flux

A Numerical Study on Heat Transfer Performance of Microchannels with Different Surface Microstructures

Three-dimensional analysis of heat transfer in a micro-heat sink with single phase flow

Fluid Flow And Heat Transfer Characteristics In Rectangular Microchannels

An Analytical Solution of Convective Heat Transfer in Microchannel or Nanochannel

Numerical Simulation of Laminar Heat Transfer of Equal Wall Temperature in Parallel Micro Channel

Simultaneously developing flow and heat transfer in circular and parallel-plates microchannels with velocity slip and temperature jump

Effect of Axial Heat Conduction on Heat Transfer in Micro-Channels

Experimental investigation on single-phase convection heat transfer in annular gap

Numerical Study of Forced Convection in a Vertical Channel Filled with Heat-Generating Porous Medium

Numerical Analysis of the Axial Heat Conduction with Variable Fluid Properties in a Forced Laminar Flow Tube

Experimental and Numerical Study of Fluid Flow and Heat Transfer Characteristics in Microchannel Heat Sink with Complex Structure

Experimental and Numerical Studies of Liquid Flow and Heat Transfer in Microtubes

Numerical Studies of Simultaneously Developing Laminar Flow and Heat Transfer in Microtubes with Thick Wall and Constant Outside Wall Temperature

HEAT TRANSFER CHARACTERISTICS OF WATER FLOWING THROUGH MICROCHANNELS