Simulation of the Effect of the Structure and Location of Non-Closed Droplet Microchannel on Flow/ Thermal Performance
Huiyan Liu,Junye Hua,Keyi Sang,Hai Lan,Baolian Niu,Wei Wu
DOI: https://doi.org/10.1016/j.icheatmasstransfer.2024.107840
IF: 6.782
2024-01-01
International Communications in Heat and Mass Transfer
Abstract:In order to investigate the effects of geometric parameters and flow modes on the fluid flow morphology, resistance and heat transfer effect in the non-closed droplet pin fin array, in this manuscript, a numerical simulation has been conducted under Re = 100-700 with different pin fin heights (H-p = 0.3 mm, 0.5 mm, 0.7 mm) and pin fin densities (beta = 0.046, 0.059, 0.072), with different flow directions under heat flux (10 W/cm(2) - 50 W/cm(2)) studied as well. It is discovered that increasing the height and density of the non-closed droplet pin fin increases the interference with the fluid, resulting in a greater flow resistance phenomenon. However, the enhancement of turbulence not only exacerbates the flow instability in microchannels, but also further promotes the mixing of hot and cold fluids, making the internal temperature distribution more uniform. In which way, the effect of optimizing heat transfer performance achieves. In addition, as q > 20 W/cm2, the overall heat transfer capacity of flow direction B (the tip of the pin fin as upstream fluid direction) is better than that of flow direction A (the cavity of the pin fin upstream as upstream fluid direction). When q = 30 W/cm(2), there is a process transferring from single-phase flow to two-phase flow along with the direction of working fluid flow in the microchannel. Under this condition, the local maximum heat transfer coefficient is 15,502.4 W/(m(2)center dot K) in flow direction A and 16,094.8 W/(m(2)center dot K) in flow direction B. Furthermore, the comprehensive evaluation concludes that the channel flow/thermal performance is the best with H-p = 0.7 mm, beta = 0.046.