Burning behavior of the typical upholstered seating-chair materials on the test with a cone calorimeter
Hong-shuang WANG,Li LI,Long-long ZHU,Chang-hai LI,Shou-xiang LU
DOI: https://doi.org/10.13637/j.issn.1009-6094.2018.01.016
2018-01-01
Abstract:The main purpose of this article is to investigate the fire safety quality of the typical upholstered seat materials,which serves as a key component of the overall system safety for coaches,house furnishings,and passenger train seats.For the above research purpose,we have tested 3 kinds of synthetic materials,that is,the polyurethane foam/artificial leather synthetics,the polyurethane foam/chemical fiber synthetics and the polyurethane foam/nylon synthetics at different heat fluxes and analyzed a series of their key fire-proof indexes by using a cone calorimeter.To understand the ignition points of the different synthetic materials here involved,we have analyzed the critical heat flux for the fibre crack before their ignition,the ignition time and the critical heat flux for ignition.The results of our examination show that all of the 3 kinds of synthetic materials are suitable to be measured with the thermally thick heating model,though the polyurethane foam and the synthetic leather enjoys better heat resistant toughness than the other two while the polyurethane foam/nylon can keep longer and higher critical heat flux for ignition,which indicates that nylon behaves better in flame-retardant properties.As to the heat release rate among the three kinds of materials,it can be found that,when the polyurethane foam/artificial leather is fully burnt,two growth peaks can be found with their heat release rate to be respectively caused by the main combustion process of the covering fabric of artificial leather and the polyurethane foam filler.However,there exists only one growth peak for polyurethane foam/chemical fibre syntheses and the polyurethane foam/nylon one,whose coverings melt easily under the heat radiation without any clear peak in the heat release rate.Besides,the single peak value under the heat flux of 50 kW/m2 tends to be greater than 600 kW/m2,which is far higher than that of the polyurethane foam/artificial leather.In addition,we have also investigated the fire hazards of the three kinds of syntheses under the different heat radiation through their fire indicators of fire growth rate (FIGRA),fire growth index (FGI),and Petrella risk matrix.Thus,the evaluation model through FGI and petrella fire-risk matrix should be expected more suitable than that of FIGRA for the above mentioned three kinds of syntheses.Therefore,the results of our experimental tests in this article should be in a position to provide a series of basic theoretical and technical data background supports for founding the fire prevention and fire risk assessment system for the upholstered seats.