Abstract:The paper reports the main features of electrochemical deposition of nickel-iron alloy from electrolyte based on the eutectic mixture of choline chloride and ethylene glycol, which is a typical representative of a new type of ionic liquids, deep eutectic solvents (DES). It is found that the iron content in the deposited alloy increases with both increasing the applied cathode current density and increasing the concentration of iron ions in the electrolyte and the introduction of water additives. Thus, variation in the current density and the concentration of water additive in electrolytes based on DES is the factor of influence on the kinetics of partial electrode reactions, and hence on the composition and properties of the coating. It is shown that it is possible to deposit uniform coatings with iron content up to 10–13% from the investigated electrolyte containing water additive (up to 10 wt.%) at the deposition current density not exceeding 1–1.2 A/dm2. The current efficiency of the alloy deposition is close to the theoretical value (97–99%), i.e. the electrodeposition is practically not complicated by electrochemical processes involving components of a deep eutectic solvent. The surface of pure nickel deposited from an electrolyte based on DES without additional water is quite uniform with a small number of defects, pitting and small pores, while coatings deposited from the electrolyte containing water additives are characterized by granular surface morphology with many asymmetric spheroidal crystallites. The electrodeposition of a nickel-iron alloy yields the surface built of irregular spheroids that overlap and form a scaly-like type of surface morphology. Nickel-iron electrolytic coatings containing up to ~7% Fe, formed from the ethaline-based electrolyte, are nanocrystalline solutions of iron in nickel with a face-centered cubic nickel lattice and an average nanocrystallite size of about 6–15 nm. Nickel-iron alloy coatings electrochemically deposited under the conditions established in this work may be considered as promising electrode materials for the creation of new cheap and highly efficient electrocatalysts for water electrolysis in hydrogen energy.

Electroless Deposition and Characterization of Nickel Coating in Lead-and Cadmium-free Bath

ZINC-NICKEL ALLOY ELECTROPLATING IN AN ALKALINE BATH

Electrodeposition and Characterization of Nano-Structured Black Nickel Thin Films

Study on Properties of Electroless Plating Nickel-phosphorus Bright Alloy Coating

Effect of electroless deposition on the corrosion resistance property for NdFeB permanent magnets with surface coating of Ni-P alloy

Novel Electroless Nickel Plating Process

A Method for Electroless Nickel Plating on Aluminum Alloy Surface

High Hardness and Wear Resistance Electroless Ni-P Deposits Without Heat Treatment

Study of Electroless Ni-Zn-P Alloy Plating from Acidic Bath

Microstructural Characterization and Corrosion Behaviors of Ni-Cu-Co Coatings Electrodeposited in Sulphate-Citrate Bath with Additives

On the Electrodeposition of Nickel–zinc Alloys from a Eutectic-Based Ionic Liquid

Characterization of a zinc-nickel alloy coating obtained from an electrolytic bath produced with spent batteries as raw materials

Effect of Deposition Time and Temperature on the Performance of Electroless Ni-P Coatings

Study on Iron-Nickel in Var Alloy Prepared by Electrode Position

Optimization of Black Nickel Coatings’ Electrodeposit onto Steel

ELECTRODEPOSITION OF NANOCRYSTALLINE NICKEL-IRON ALLOY FROM AN ELECTROLYTE BASED ON A NEW TYPE OF IONIC LIQUIDS – DEEP EUTECTIC SOLVENT

Tailoring Nickel Coatings Via Electrodeposition from a Eutectic-Based Ionic Liquid Doped with Nicotinic Acid

Electrodeposition of Nanostructured Co–Cu Thin Alloy Films on to Steel Substrate from an Environmentally Friendly Novel Lactate Bath under Different Operating Conditions

Influence of Electrodeposition Conditions on the Microstructure and Corrosion Resistance of Zn–Ni Alloy Coatings from a Deep Eutectic Solvent

Electrochemical Synthesis and Characterization of Ni–P Alloy Coatings from Eutectic–Based Ionic Liquid

Corrosion Resistance Of Electrodeposited Nanocrystalline Ni From Citrate Baths