Abstract:High quality and ambulatory measurements of biosignal, especially some weak biopotential signals with amplitude less than 1 mu V is significant for the follow-up applications and is still challenging. This paper presents a new low-noise, high-performance active electrode design for such weak biosignal measurements. The proposed active electrode is designed in the fully-differential configuration in combination with the right-leg driven signal, which is seldom included in the previous design of active electrodes. Main advantages of this design lie in further improving the common-mode interference rejection with introducing right-leg driven signal and ideally driving differential inputs of ADS1299 to extract 1 mu V level biosignal from other large noises voltages with the fully-differential configuration. The active electrode achieves 4.52 mu Vrms (0.5 - 200 Hz) input referred noise and 96.09 dB CMRR at 10Hz. Two preliminary verification experiments of ECG and EMG were performed using the traditional passive electrodes and the proposed active electrodes for comparison. The results demonstrated the benefits of the active electrode in terms of main interference suppression like power line interference and motion artifacts over the passive electrode. Therefore, the proposed active electrode with low noise and high CMRR could be used in weak biosignal (1 mu V level) measurements in the future.

New Design of Preamplifier Circuit for ECG Signal

Design of Pre-processing Circuit for Wireless ECG Monitoring System

Design of Ecg Signal Acquisition and Processing Circuit

The Design of EEG Signal Acquisition Pre-processing Circuit

A Design of EES Analog Pre-processing Circuit

Design of preamplifier and anti-interference for the portable ECG monitor

Design of an EEG Preamplifier for Brain-Computer Interface

Analysis and Implement of ECG Front-End Signal Processing Circuit

Design of 16-Channel EEG Signals Preprocessor

A Single-Channel Amplifier for Simultaneously Monitoring Impedance Respiration Signal and ECG Signal

Circuit Design of Portable ECG Equipment Based on LM124 Operational Amplifier

A Design of A Combined-Lead ECG Monitoring System with Low-Power and WSN

A Low Power Low Noise Front End Amplifier for ECG Monitoring

Printed Circuit Board Design of ECM of Multi-lead ECG Monitoring System

Circuit Design For Neural Signal Recording With Cuff Electrode

Design of a Low Electrode Offset and High CMRR Instrumentation Amplifier for ECG Acquisition Systems

Low-cost circuit design of EEG signal acquisition for the brain-computer interface system

The Design of Pre-Amplifier Module in the 128-Channel Epicardial Potential Mapping System

Reserch and design of real-time ECG analyzing system based on CEP

Development of the single-supply ECG amplifier circuit with low power

An Active Electrode Design For Weak Biosignal Measurements