Phase equilibria and microstructural control in the Ni-Co-Al system

R. Kainuma,M. Ise,C.-C. Jia,H. Ohtani,K. Ishida
DOI: https://doi.org/10.1016/0966-9795(96)00034-9
IF: 4.075
1996-01-01
Intermetallics
Abstract:This paper is a report of the results of investigations on the phase equilibria among gamma (Al), and gamma' (L1(2)) and beta(B2) phases, beta --> beta' (L1(0)) martensitic transformation temperatures, and microstructural features of multi-phase alloys fabricated through various thermo-mechanical processes in the Ni-Co-Al system. The isothermal section diagrams and tie line configurations of 900, 1100 and 1300 degrees C was determined by energy dispersion X-ray spectrometry (EDX) analysis. The Ms temperature was measured by differential scanning calorimetry (DSC) analysis and a contour of iso-Ms composition lines was determined. On the basis of this information, the various types of microstructure of beta + gamma, beta + gamma' and beta + gamma + gamma' phases was obtained through thermo-mechanical treatment. Morphological features of the multi-phase alloys with fine blocky, plate, Widmanstatten and lamellar structures was discussed in connection with heat-treatment, phase diagram and martensitic transformation. Mechanical properties were also examined and a good combination of strength and ductility was obtained in the multi-phase alloys. Copyright (C) 1996 Elsevier Science Ltd.
What problem does this paper attempt to address?