Abstract:Numerical analyses are performed to investigate ultrasonic wave propagation in fluid-solid half-spaces subject to a directional source. This research is particularly concerned with the behavior of refracted waves within fluid mediums and their utility in determining the acoustic velocities of solid materials. The simulations encompass solids with various mechanical parameters and highlight the influence of incident angles on wave propagation. The analysis reveals that as the disparity between incident and critical angles increases, both the dominant frequencies and amplitudes of the corresponding refracted waves decrease substantially, which is detrimental to the accurate extraction of solid velocities. For the low-velocity solid characterized by its shear wave velocity being less than the fluid's acoustic velocity, refracted longitudinal waves are susceptible to interference from direct and reflected waves. This interference often results in underestimated velocity measurements. The challenge can be addressed by either extending the source-receiver offset or by adjusting the incident angle closer to the critical angle. Regarding solids with shear wave velocities exceeding the fluid's acoustic velocity, although the velocity-time correlation (VTC) method can accurately determine longitudinal wave velocities, shear wave velocity extraction may be compromised by the presence of the leaky Rayleigh wave. We further compare velocities calculated by dividing the spacing distance of two receivers by the time difference of their respective wave packet arrivals. Results indicate that the initial trough and peak of the S wave packet are predominantly influenced by refracted shear waves and the leaky Rayleigh wave, respectively. This occurs because refracted shear waves propagate slightly faster than the leaky Rayleigh wave. Consequently, using the first trough of the shear wave packet as the wave onset can mitigate the impact of the leaky Rayleigh wave, yielding precise shear wave velocity measurements. These studies are of considerable importance for applications in geophysical downhole measurements and nondestructive testing.

The Experiment on the Principle of the Ultrasonic Measurement

Research on Ultrasonic Measurement of the Large Curved Surface Parts

Research of the Ultrasonic Distance-Measure Instrument

Distance Measurement Via Ultrasonic

Expand experiment of ultrasonic velocity measurement

Measurement insights and error analysis of electronic parameters for ultrasonic transducers

Application of ultrasonic wave measurement and control circuits in circuit design course

The calibration of laser ultrasonic system

Fundamental Theory and Apparatus for Speed of Sound Measurement System Using Cylindrical Resonator

The Transducer Study of Ultrasonic in Solid by Finite Element Simulation

A new method for the measurement of velocity ratio ofhigh power ultrasonic vibrating system

An Undergraduate Experiment for the Measurement of the Speed of Sound in Air: Phenomena and Discussion

The System and Method of Ultrasonic Testing Based on Linear-Frequency-Modulation Technique

Design of testing ultrasonic parameter circuit

Design of Ultrasonic Liquid Level Measuring System under Complicated Circumstances

An Ultrasonic Distance Measurement System Based on Single-Chip Computer

Applications of the Finite Element Method in the Ultrasonic Flow Measurement

Obliquely incident ultrasonic wave propagation in a fluid-solid configuration and solid velocity measurements

Laser-induced Ultrasonic Surface Wave Velocity

Application of Ultrasonic Technology to the Field of Electronic Special Equipments

Improvement of Ultrasonic Distance Measuring System