Abstract:The measurement of elastic constants is very important to the study of materials. Laser ultrasonic technology has been widely concerned for its unique advantages and used to measure elastic constants, but the current measurement methods have their limitations. In general, traditional measurement methods require the use of a fatigue tester or measurement of all modal waves during the experiment. It is found that cracks can transform the mode of ultrasonic wave, in other words, the surface acoustic waves can be transformed into shear waves by mode conversion. So, we proposed a new method of measuring elastic constants of materials by laser ultrasound based on mode conversion. Surface acoustic waves are induced by laser ultrasound system, the reflection and mode conversion of surface acoustic waves can be realized by cracks. Therefore, direct waves, reflected waves and mode converted waves are included in the collected surface wave signals, then the wave velocity of surface waves and shear waves are calculated by the surface acoustic waves, and the elastic constants of materials are obtained by the acoustic elasticity equation. Since the experiment and processing are all based on surface acoustic waves, multiple waveform acquisition and processing are avoided. After calculation, the error is kept below 3% compared with the standard measurement value. In order to further confirm the application range of the method, cracks of different depths are used in the experiment, it is further proved that this method has nothing to do with the crack size. The research results of this paper can extend the application range of laser ultrasound. It also provides a new approach to the characterization of materials.

Laser-induced Ultrasonic Surface Wave Velocity

A Novel Laser Ultrasonic Thickness Measurement Method for Metal Plate Based on Spectral Analysis

Quantitative Detection of Surface Defect Using Laser-Generated Rayleigh Wave with Broadband Local Wavenumber Estimation

Influence of Initial Time of Laser Ultrasonic on Calculating Its Propagation Velocity in a Diamond Anvil Cell.

Laser-ultrasonic investigation on Rayleigh wave propagation in surface micro-str uctures

Development Of High-Precision Ultrasonic Microscopy Measurement System And Measurement Of The Surface Wave Velocities Of (100) Silicon Wafer

Laser-generated Surface Waves for Quantitative Detection of Inclined Surface Cracks Based on Finite Element Analysis

Measurement of Velocity Distribution of Laser-Generated Rayleigh Wave on Welded Structure

Study of AFM-based probe for detecting laser induced surface acoustic wave

Scanning high-power continuous wave laser-generated bulk acoustic waves.

An Experimental Method of the Laser-generated Ultrasonic Waves for Detecting the Surface-breaking Defects

Numerical Simulation of the Ultrasonic Waves Generated by Ring-Shaped Laser Illumination Patterns

A High-Resolution Ultrasonic Ranging System Using Laser Sensing and a Cross-Correlation Method

Simultaneous measurement of thickness and ultrasonic wave velocity using a combination of laser-generated multiple wave modes in the thermoelastic regime

Numerical simulation of laser ultrasonic detection of surface micro-crack depth

Numerical Simulation of Laser Ultrasonic Surface Wave Measurement of Residual Stress

Experimental and Theoretical Analysis of the Dispersion of Laser-Induced Surface Acoustic Wave Due to Surface Roughness

The calibration of laser ultrasonic system

Laser Ultrasonic Measurements for Generation and Detection of Lateral Waves in a Solid for Surface Defect Inspection

Study on liquid surface wave detection based on laser Doppler effect

Laser-induced Surface Acoustic Waves for Measurement of Elastic Constants Based on Mode Conversion