Abstract:The addition of Fe2O3 into furnaces is a promising method for arsenic pollution control. Nevertheless, Fe2O3 particles undergo serious sintering under actual furnace temperatures. To improve its sintering resistance, Fe2O3 hollow microspheres were synthesized by the template method and were tested in flue gas containing SO2 and NO in the range of 1000–1300 °C. The results demonstrated that the amount of arsenic captured could be steadily maintained above 5 mg/g throughout the operating temperature range, and Fe2O3 microspheres could maintain the originally developed pore structure and hollow morphology well even at 1200 °C. Based on product analysis and density functional theory calculations, the fixation pathway of arsenic was proposed. In no oxygen conditions, As2O3 was first bound to the Fe2O3 surface by forming an −O–As–O–Fe stable structure and then was oxidized by lattice oxygen. The introduction of O2 could regenerate the consumed lattice oxygen and therefore promote arsenic capture. Finally, the oxidized arsenic was fixed in products in the form of FeAsO4. Additionally, the impact of acid gases was also investigated. SO2 showed a notable inhibiting effect on arsenic capture, while the impact of NO was less noticeable.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.est.1c02381?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.est.1c02381</a>.Partial data regarding structural changes of Fe2O3 microspheres before and after the reaction (<a class="ext-link" href="/doi/suppl/10.1021/acs.est.1c02381/suppl_file/es1c02381_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Preparation of nanometer-size amorphous powders of arsenic by γ-irradiation at room temperature

Gamma-Radiation Synthesis Of Nanometer-Size Amorphous Cr2o3 Powders At Room Temperature

Atomic Investigation on the Facet‐Dependent Melting of Ceramic Nanostructures Via in Situ Electron Irradiation

Preparation of nanometer-size selenium powders of uniform particle size by γ-irradiation

A Safe Low Temperature Route to Nanocrystalline Transition Metal Arsenides

Preparation of nanocrystalline indium powders by use of γ-ray radiation

Preparation of nanocrystalline antimony oxide powders by use of γ-ray radiation — oxidization route

Enhancing the anti-oxidation stability of vapor-crystallized arsenic crystals via introducing iodine

Preparation of Nanocrystalline Cobalt Powders by a Γ-Irradiation Method

Preparation of nanocrystalline silver powders by γ-ray radiation combined with hydrothermal treatment

Effects of Preparation Parameters on Room Temperature Formation of Vanadium-Doped Tio2 Nanocrystalline Powder

γ-Irradiation preparation and characterization of nanocrystalline ZnS

A safe sonochemical route to iron, cobalt and nickel monoarsenides

In-Furnace Control of Arsenic Vapor Emissions Using Fe 2 O 3 Microspheres with Good Sintering Resistance

Preparation Of Nanocrystalline Cadmium Powder By The Gamma-Radiation Method

Preparation of Nanocrystalline Fe3O4 by Γ-Ray Radiation

Preparation and Structural Characterization of Nano-Sized Amorphous Powders of MoS2 by Γ-Irradiation Method

Preparation of YAG Nano-Powders Via an Ultrasonic Spray Co-Precipitation Method

Preparation of nano-sized SrAl2O4 using an amorphous hetero-nucleus complex as a precursor

Nanoscaled YAG Powders Via Coprecipitation Using Ammonium Hydrogen Carbonate As the Precipitant

Ultrasonic Spray Co-Precipitation for YAG Nano-Powders Preparation