Temperature and Humidity Characteristics of Flue Gas from Combined Wet Flue Gas Desulfurization System and Heterogenous Condensation

XIONG Guilong,XIN Chengyun,YANG Linjun,LU Bin

DOI: https://doi.org/10.13334/j.0258-8013.pcsee.2011.08.003

2011-01-01

Abstract:An experimental investigation on the flue gas temperature and humidity characteristics at the outlet of desulfurization scrubber was conducted.Influence of the operating parameters for typical wet flue gas desulfurization(WFGD) technology of limestone-gypsum processes on flue gas temperature and humidity measured by a Vaisala-HMT337 type temperature and humidity sensor were analyzed.The experimental results show that increased temperature of the scrubbing liquid brings a higher relative humidity and temperature of flue gas.An increase in liquid-to-gas ratio causes a greater relative humidity but a lower temperature of flue gas,which is opposite to the inlet temperature of flue gas.The supersaturated water vapor environment established in flue gas has a great influent on the removal efficiency of fine particles,so a mathematical model for ideal mixing between high humidity flue gas and water vapor was established and numerically analyzed by MATALBA software.The simulation results indicate that the degree of super-saturation of the flue gas added steam increases with the increasing amount of vapor and humility of the original flue gas,but evidently decreases with the increasing temperature of the original flue gas.The supersaturated water vapor environment can be formed in flue gas by optimizing the operating parameters of wet flue gas desulfurization system and adding some amount of steam,in which fine particles could be promoted to grow up and then removed by a demister mounted at the top of the steam phase-change chamber.