Abstract:It was discussed that the research progress and technical achievements had been obtained in the field of residual stress measurement and control of high-grade and large-diameter welded pipe for oil and gas transportation in China. (1) The layout scheme of measuring points and the requirements of spaces between measuring points, hole depth, etc., for residual stress measurement of welded pipe using hole drilling strain-gage method were proposed. On which, the residual stress measurement technology for welded pipe was proposed. (2) The measurement results indicate that the characteristics and distribution of residual stress of SAWH pipes with different grades and sizes were quite different. In general, the residual stress of SAWH pipe was highest, followed by JCOE pipe and UOE pipe. After the ring splitting test, SAWH pipe section usually had relative displacement in circumferential, axial and radial directions, and the degree of deformation varies greatly; But SAWL pipe section usually only occurs circumferential opening, without axial and radial stagger, and the circumferential opening of JCOE pipe was usually larger than that of UOE pipe. (3) Based on the mechanical analysis of the complex deformation of SAWH pipe after the ring splitting test and the superposition principle of elastic mechanics, a prediction model of the residual stress of the high-grade and large-diameter welded pipe suitable for SAWH pipe was established, which overcame the deficiency of the existing prediction models of the residual stress of the welded pipe only considering the circumferential deformation. (4) The key forming parameters affecting the residual stress of SAWH pipe were analyzed and determined as the reduction and forming angle. Combined with the finite element simulation analysis, field adjustment and residual stress analysis, the forming technology and residual stress control technology of low residual stress SAWH pipe were developed.

Study of the Elastoplastic Contact Characteristics of Threaded Joints of Oil Pipes with Large Dimensional Deviations

Elasto-plastic Solution for Tunnelling-Induced Nonlinear Responses of Overlying Jointed Pipelines in Sand

Nonlinear Analysis of the Threaded Connection with Three-Dimensional Finite Element Model

Simulation and Analysis of UOE Pipe Production Processing by Three-Dimensional Finite Element Method

A study of the ultimate compressive strain of local buckling in strain-based design of pipelines

Finite Element Simulations of Working Characteristics of Solid Expandable Tubular Threaded Joint

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Buckling Response of Offshore Pipelines under Combined Tension and Bending

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Finite Element Simulations of Mechanical Properties of Solid Expandable Tubular Threaded Joint

Mechanical study on overbend segment of submarine pipeline during S-Lay

Parametric study on the mechanical behavior of submarine pipeline for deepwater S-lay operation

EXPERIMENTAL STUDY OF THE BEARING CAPACITY OF INTERNAL|EXTERNAL FLANGE JOINTS SUBJECTED TO PRESSURE AND BENDING LOADINGS WITH VARIOUS ECCENTRICITIES

Study on tightening characteristics of flareless pipe joint assembly process

Nonlinear Analysis on Ultimate Flexural Bearing Capacity of the N-Shaped Steel Tubular Joints

Non-Linear Analysis of Ultimate Loading Capacity of Cast Tubular Y-Joints under Axial Loading

Analysis of expansion performance and parameter sensitivity of solid expandable tubular with thread joint

Bilinear Constitutive Model-Based Theoretical Study on Interfacial Properties of Pipeline Joints Coupling Tension and Temperature

Finite Element Analysis of the Pipe-through Welded Ball Joints

Plastic Limit Load Analysis of Tee Joint Containing Corner Cracks

Measurement and Control of Residual Stress of High-Grade and Large-Diameter Welded Pipe for Oil and Gas Transportation