Abstract:Metallic phononic crystals (PhCs) with characteristic length in micrometers can have bandgaps in the MHz regime and are suitable as bulk and surface acoustic wave devices. Fabrication of such PhCs either in batches or large scale using advanced machining techniques based on lasers, electron beams, or ion beams is too slow and expensive. In this work, we demonstrated two methods of fabricating metallic PhCs from stainless steel SS304 and identified their bandgaps. Two PhCs were fabricated using electrochemical anodic dissolution using wire-electrochemical micromachining (wire-ECMM) and three PhCs by melting and vaporization of the substrate using wire-electric discharge machining (wire-EDMM). Using these methods, a square array of micropillars of square cross-section were machined over surfaces of SS304 substrate with a cross-sectional area of 1 cm . Each PhC was considered to have the micropillars as the scatterers and air, water, or epoxy as the host. Dispersion relations and transmittance were evaluated using the finite element method. Both types of simulation results revealed the presence of partial and complete bandgaps for the different PhCs in the frequency range of 0.1 3.5 MHz. As texturing the surface alters the lyophilic or lyophobic nature of the surface, this work paves the way to explore the development of multifunctional metamaterials.

Fabrication of Near Infrared Metallodielectric Photonic Crystal Using Metal-Coated Dielectric Spheres

Mid-infrared dual-cladding photonic crystal fiber with high birefringence and high nonlinearity

Decorative near-infrared transmission filters featuring high-efficiency and angular-insensitivity employing 1D photonic crystals

Two-Dimensional Metallodielectric Photonic Crystal with A Large Band Gap

Photonic Band Gaps from Metallo-Dielectric Spheres

Preparation Of Metallic-Dielectric Spheres Used To Fabricate Photonic Crystals With Electroless Plating Method

The Resonance-Induced In-Gap Modes in Photonic Crystals Composed of Metal-Coated Dielectric Spheres

Fabrication of Metallodielectric Photonic Crystals with a Diamond Structure and their Microwave Properties

Photonic Band Gaps of AB3 and B3 Structures of Metallodielectric Spheres

Fabrication of High Quality Three-Dimensional Photonic Crystals

Fabrication and Properties of Multilayer-Coated Core–shell Structural Monodisperse Spheres and Close-Packed Structure

Three-Dimensional Self-Assembly of Metal Nanoparticles: Possible Photonic Crystal with A Complete Gap below the Plasma Frequency

Absorption in One-Dimensional Metallic–dielectric Photonic Crystals

Photonic Band Gaps of Ab(3) and B-3 Structures of Metallodielectric Spheres

Characteristics Modeling of Photonic Crystal by Using Numerical Techniques

Optical Metamaterials at Near and Mid-Ir Range Fabricated by Nanoimprint Lithography

Photonic crystals of coated metallic spheres

Optical transmission of corrugated metal films on a two-dimensional hetero-colloidal crystal.

Fabrication of a Reflective Mirror Within Wide Incidence Angles for Mid-Infrared Wavelength

Existing conditions of full bandgaps and absolute negative refraction in metallic-dielectric photonic crystal

Fabrication and bandgaps of microscale metallic phononic crystals