Abstract:Indium hydroxide (In(OH)(3)) nanorods and Sn-doped indium oxyhydroxide (InOOH) nanoparticles were synthesized through the hydrothermal method in an aqueous solution. Sodium hydroxide (NaOH) was introduced to adjust the pH value, and sodium acetate (CH3COONa) was employed as the inducer to accelerate the growth along the preferential orientation. Cubic In(OH)(3) was synthesized at pH values ranging from 4.0 to 8.0. In(OH)(3) nuclei grows in the direction {100} into nanorods observed from lattice fringes with an interplanar spacing of about 0.403 nm. The SAED pattern of In(OH)(3) nanorods indicates the rodlike nanocrystal is a single crystal which matches well with the characteristic peaks of cubic In(OH)(3) XRD patterns. The FTIR spectrum signifies the absorption of CH3COO- onto the surface of In(OH)(3) nanorods, which accelerate the growth along the direction {100}. Due to the inhibition effect of OH-, In(OH)(3) particles with a smaller aspect ratio and In2O3 particles with a smaller crystal size were synthesized with the increase of pH values. At a high hydrothermal temperature, cubic In(OH)(3) transformed into orthorhombic InOOH owing to the dopant of Sn with a size smaller than In3+ and r(Sn4+)/r(O2-) = 0.58. The lattice fringes and SAED patterns of InOOH and hexagonal In2O3 nanoparticles were determined. It was also observed that the average size increased from 27 to 46 nm when Sn doping content increased from 2% to 10%. The sensors based on the Sn-doped In2O3 nanoparticles showed a fast (6-7 s) and high response (R-a/R-g = 8.9) to 100 ppm acetone at an operating temperature of 280 degrees C. This work provides a preliminary investigation into the effect of sodium acetate and Sn on the growth of In(OH)(3) nuclei.

Preparation and characterization of indium-doped tin dioxide nanocrystalline powders

Transparent P-Type Conducting Indium-Doped SnO2 Thin Films Deposited by Spray Pyrolysis

The Characterization and Preparation of Nano Scale Fe Doping TiO2 by Sol Gel Method? the Crystallization and Thermal Decomposition Process of Fe Doping TiO2 Xerogel Powders Using Thermal TG IR Spectrometry

The Characterization And Preparation Of Nano-Scale Fe Doping Tio2 By Sol-Gel Method - (Ii) - The Crystal Character And Grain Growth Of Fe Doping Tio2 Xerogel Powders

Characteristics of Nano Ti-doped SnO2 Powders Prepared by Sol–gel Method

Preparation And Characterization Of Nano-Yb2o3/Tio2 Particles

Hydrothermal Preparation and Characterization of Nanocrystalline Powder of β-Indium Sulfide

Preparation of In(OH)(3) and In2O3 Nanorods Through a Novel Hydrothermal Method and the Effect of Sn Dopant on Crystal Structures

A Study on the Influencing Factors in the Preparation of Bismuth-doped Tin Oxide Nano-powders by Co-Precipitation

Preparation of Corundum Structure Sn-Doped In2o3 Nanoparticles Via Controlled Co-Precipitating and Postannealing Route

Preparation and Characterization of Ni、Co、Cr、V Doped TiO_2 Nanoparticles

Preparation of CuO-TiO2 nanocrystalline powders by the sol-gel method

PREPARATION OF IRON-DOPED TITANIA NANOCRYSTALLINE GRAINS AND ITS PHOTOCATALYTIC PROPERTY

Molecular Mechanism of Monodisperse Colloidal Tin-Doped Indium Oxide Nanocrystals by a Hot-Injection Approach.

Effects of Preparation Parameters on Room Temperature Formation of Vanadium-Doped Tio2 Nanocrystalline Powder

Preparation and Electrical Properties of Electrospun Tin-Doped Indium Oxide Nanowires

Preparation and electrochemical properties of nanosized tin dioxide electrode material by sol-gel process

Hydrothermal Preparation and Characterization of Nanocrystalline Porous Tin Dioxide Thin Films

Synthesis and Characterization of Sn1-xBixO2 Nano-powder

Preparation and Characterization of Nano-Tio2 Powder

ChemInform Abstract: Organothermal Synthesis and Characterization of Nanocrystalline Β‐indium Sulfide.