Abstract:• Doped/co‐doped SnO2 compounds with different element combinations were synthesized using the sol–gel method. • Pure and doped SnO2 samples were produced in the nanoscale. • With doping, changes in pore volume–pore width, energy differences in the optical band gap, and variety in microstructures were observed. • In addition, doped SnO2 samples are compatible with each other in terms of particle size, surface area, and crystal structure. Tin oxide (SnO2) is one of the important semiconductors used in the application of solar cells because of its chemical–mechanical stability and wide band gap. These properties are very important for the performance development and photoanode optimization of a dye‐sensitized solar cell (DSSC). However, the low conduction band value of SnO2 reduces the photovoltaic efficiency, which limits the application of DSSC. Therefore, the doping strategy was used to increase the sensitivity to the visible light spectrum and change the light absorption properties of SnO2. In this paper, pure SnO2, Ag/SnO2, Pt/SnO2, and Pt/Ag/SnO2 nanoparticles were synthesized at the nanoscale by a simple chemical sol–gel method. To characterize the structure, morphological/chemical properties, optical properties, and surface properties of the synthesized SnO2 nanoparticles, X‐Ray Diffraction (XRD), ultraviolet–visible, Brunauer–Emmett–Teller, Scanning Electron Microscopy (SEM)/Energy Dispersive X‐Ray Spectroscopy (EDX), Transmission Electron Microscopy (TEM), and particle size analysis were respectively used. XRD results showed that the crystal sizes varied between 8.8 and 12.2 nm depending on the doping. Doping processes resulted in reductions in particle sizes. Optical studies resulted in decreases in the band gap with the doping process. The conclusions obtained have shown that Ag doping, and Pt–Ag co‐doping can be promising for use as photoanode materials in semiconductor technology and especially in DSSC applications.

Characteristics of Nano Ti-doped SnO2 Powders Prepared by Sol–gel Method

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

The Characterization And Preparation Of Nano-Scale Fe Doping Tio2 By Sol-Gel Method - (Ii) - The Crystal Character And Grain Growth Of Fe Doping Tio2 Xerogel Powders

Preparation and Properties of CaTiO_3:Zn Nanoparticles Based on Sol-Gel Method

Synthesis and Characterization of Sn1-xBixO2 Nano-powder

Sol-Gel Preparation of N-doped TiO2 Nanocrystalline at Low Temperature

Preparation and Characterization of Ni、Co、Cr、V Doped TiO_2 Nanoparticles

Preparation of CuO-TiO2 nanocrystalline powders by the sol-gel method

Sol-gel synthesis and properties of zinc doped tin oxide (Zn-SnO2) nanostructures

Preparation and Characterization of Nano-Tio2 Powder

Preparation and electrochemical properties of nanosized tin dioxide electrode material by sol-gel process

Fabrication of V-Doped TiO2 Nanoparticles and Photocatalytic Studies under Visible Light

Sol-Gel Preparation and Optical Properties of Ag Nanoparticle/TiO2 Composite Films

Characterization and Mechanism Elucidation of Nano-TiO2 Composites Prepared by Gaseous Detonation Method

Synthesis and characterization of the doped/co‐doped SnO2 nanoparticles by the sol–gel method

A study on the nanocrystalline titanium dioxide synthesized by ultrasonic-assisted sol-gel process

Effect of La doping on microstructure of SnO2 nanopowders prepared by co-precipitation method

Growth and Optical Properties Investigation of Pure and Al-doped SnO2 Nanostructures by Sol-Gel Method

Characterization and Electrical Properties of Sol-Gel Synthesized (sr, Pb)TiO3 Powders

Preparation of nanometer NiO powders doped Li+ by a sol gel method and its conductivity