Abstract:• An absorption heat exchanger under low flow rate ratio (1.72–3.72) is tested. • The tested heat transfer effectiveness is 0.954–1.196. • A simulation model is established and validated with tested data. • Operation characteristics under different flow rate ratios are studied in model. • Parallel-series connection is proposed firstly, which has a better performance. A two-stage absorption heat exchanger (AHE), which consists of two absorption heat pumps (AHP) and a plate heat exchanger (HEX), is designed and utilized in a pressure isolation station in Taian, China. The AHE is usually used to solve the mismatching problem of the heat transfer when there is a high flow rate ratio of the secondary network water to the primary network. Unlike in previously studied case, the flow rate ratio of the AHE in Taian is relatively low (1.7–3.7), giving rise to the research values to test the performance of this special unit and to simulate its practical operating conditions with a numerical model. The heat transfer effectiveness of the two-stage AHE is 0.954–1.196 while the heat load rate ranges from 46.8% to 94.1%, and the outlet water temperature of the primary network is averagely 4.93 K lower than the inlet temperature of the secondary network. The AHE system shows better performance than normal PHE system even at a quite low flow rate ratio. Moreover, the numerical model is established, and the simulation results show that the standard deviation of the simulated values to the measured values is less than 1.2 K. Furthermore, some optimization strategies of the AHE are given and several performance characteristics at different flow rate ratios are found based on tested data and simulation results. And a new connection method of the secondary network through the AHE is proposed and three connection methods are compared in this research. The work could further expand the scope of application of the AHE, and contribute to reducing energy consumption in not only the district heating systems but also other energy systems.

Performance optimization of separate type heat pipe heat exchanger in plant room with high density of sensible heat load

Optimal Design of the Separate Type Heat Pipe Heat Exchanger

Entransy Dissipation Analysis and Optimization of Separated Heat Pipe System

Design and Analysis of Heat Pipe Heat Exchanger Efficiency

Passage arrangement design for multi-stream plate-fin heat exchanger under multiple operating conditions

Performance experiment of separate heat pipe air conditioning units for electronic equipment rooms

Performance Prediction and Parametric Analysis of Small Diameter Heat Exchangers Based on Distributed Parameter Model

Effect of heat exchanger design on seasonal performance of heat pump systems

Annual energy-using simulation of separate heat-pipe heat exchanger

Experimental comparison and numerical study of flow and heat transfer characteristics of the pipe rows in heat pipe heat exchanger

Performance and optimization of absorption heat exchanger under different flow rate ratio conditions

Temperature Distribution of R417A Heat Pump Type Air Conditioner Heat Exchangers

A Thermal Design Method for the Performance Optimization of Multi-Stream Plate-Fin Heat Exchangers

Discussion on Fin Structure of Heat Pipe in Energy Saving for Air-conditioning and Ventilating System

Modeling and Analysis of Two-Phase Distribution in Large-Scale Separate Heat Pipe

Air Source Heat Pump/Heat Pipe Domestic Room Heating System: Design And Experimental Research

Process Design and Analysis of a Flexibly Adjusted Zonal Absorption Heat Exchanger for High-Rise Building Heating Systems

Performance Evaluation of Fin-and-tube Heat Exchangers in an Outdoor Unit Considering Air Flow Mal-Distribution

Application of Separated Heat Pipe System in Data Center Cooling

Modelling and Applications of Annual Energy-Using Simulation Module of Separated Heat Pipe Heat Exchanger

Optimal Procedure Of Heat Exchanger Design And Its Application On Dual-Stage-Circle High Temperature Heat Pump