Abstract:Carbon fiber paper (CFP) is one of the most widely used gas diffusion layer materials for proton exchange membrane fuel cells (PEMFC) due to its excellent properties such as high conductivity, high strength, high air permeability and corrosion resistance. In this study, CFP was prepared using the phenolic resin (PF) in-pulp addition method. The effect of PF content on the properties of hot-pressed paper (HPP) and CFP was investigated. The results showed that when the dosage of polyethylene oxide (PEO) was 1.5 wt%, the flocculation effect of PEO on PF was basically complete, and the water filterability and retention of carbon fiber pulp were relatively optimal. After HPP was carbonized into CFP, the hydrophobicity, average pore size, porosity, and air permeability increased, while the resistivity and tensile strength decreased. With the increase of PF content, the tensile strength of CFP gradually increased, while the average pore size, porosity, air permeability and resistivity decreased. When the PF content was 250 wt%, the average pore size of CFP was 36.5 μm, the water contact angle was 127°, the porosity was 69.7%, the air permeability was 7.81 × 10 3 mL mm/(cm 2 ·h·mmHg), the resistivity was 21.1 mΩ cm, and the tensile strength was 15.7 MPa. In addition, the CFP prepared using PF in-pulp addition method had a relativity uniform pore size distribution and high air permeability. Therefore, this work shows that the CFP prepared using this technique exhibits excellent comprehensive performance, and enables the manufacturing of CFP to be more efficient, low-cost, and environmentally friendly.

Study on the Effect of Carbon Fiber Surface Characteristics on the Performance of Carbon Paper Used in Fuel Cell

Study on modification of carbon fiber and performance of carbon paper as gas diffusion layer

Research on Surface Treatment of Carbon Fiber and the Conductive Properties of Paper

Interfacial Modiﬁcation and Dispersion of Short Carbon Fiber and the Properties of Composite Papers As Gas Diffusion Layer for Proton Exchange Membrane Fuel Cell (PEMFC)

Study on micro-porous layer by coating on carbon fiber paper as gas diffusion layer

Chemical Treatment of Carbon Fibers and the Development of Functional Paper

Effect of Different Chemical Treatments on the Dispersion Properties of Carbon Fiber and Paper Properties

Preparation of Gas Diffusion Carbon Paper and Its Uniformity Analysis

Surface Characteristics of Different Cross-Section Carbon Fibers and Its Effect on Interfacial Adhesion Properties of Composite

Surface Treatment of Carbon Fiber and Conductive Properties of Paper

Efficient preparation and characterization of carbon fiber paper using phenolic resin in-pulp addition method

Structure and properties of carbon fiber paper with gradient porous structure

Influence of carbon paper on self humidifying performance of PEMFC

Highly flat and highly homogeneous carbon paper with ultra-thin thickness for high-performance proton exchange membrane fuel cell (PEMFC)

Role of Fiber Length and Pore Former on the Porous Network of Carbon Paper Electrode and its Performance in PEMFC

Influence of Fiber Surface Treatment on Mechanical Properties of CF/PET Composites

Performance Enhancement of Proton Exchange Membrane Fuel Cell through Carbon Nanofibers Grown In Situ on Carbon Paper

Fabrication and Application of Carbon Nanotubes/cellulose Composite Paper

Study on Carbon Fiber Surface Treatment Based on Surface Oxidation Method

Effect of grain size of graphite powder in carbon paper on the performance of proton exchange membrane fuel cell

Synergistically improve the strength and porosity of carbon paper by using a novel phenol formaldehyde resin modified with cellulose nanofiber for proton exchange membrane fuel cells