Abstract:A CMOS preamplifier for optical access network systems is realized in native CSMC 0.6 μm CMOS technology. A differential architecture is adopted to increase the common mode rejection ratio of the whole circuit, to lower the interference from supply noise and parasitic feedback paths, and to suppress substrate noise and thermal drift. Thus the noise of the preamplifier can be reduced. At the same time, its complementary outputs allow a differential interface to the following differential main amplifier. Without single-ended to differential circuit, the chip achieves monolithic integration under a simpler configuration. Using single stage architecture, the circuit is more stable than a conventional multistage one. Testing results show that the circuit gains a high bandwidth transimpedance gain product up to 1.4 THzΩ and a low equivalent input current noise of 1.81 pA/√Hz under a supply voltage of 5 V. The implemented preamplifier can operate well at standard bit rate of 155 Mb/s (STM-1).

A 10gb/s GaAs PHEMT High Gain Preamplifier for Optical Receivers

10Gb/s GaAs PHEMT Current Mode Transimpedance Preamplifier for Optical Receiver

12 Gb/s GaAs PHEMT transimpedance preamplifier for optical receiver

12 Gb/s CaAs PHEMT Transimpedance Preamplifier for Optical Receiver

An Inductorless Transimpedance Amplifier Design for 10 Gb/s Optical Communication Using 0.18-Μm CMOS

20GHz Broadband GaAs PHEMT Distributed Preamplifier

10 Gb/s OEIC Optical Receiver Front-End and 3.125 Gb/s PHEMT Limiting Amplifier

1.25 Gbit/s CMOS common-gate preamplifier for optical receiver

5Gb/s monolithically integrated GaAs MSM/PHEMT 850nm optical receiver front end

2.5 Gb/s GaAs PIN/PHEMT Monolithic Integrated Optical Receiver Front End

CMOS 1.4 THzΩ 155 Mb/s differential transimpedance preamplifier for optical receiver

A 12.5 Gb/s 1.38 mW all-inverter-based optical receiver with multi-stage feedback TIA and continuous-time linear equalizer

10 Gb/S 1.95 Mw Active Cascode Transimpedance Amplifier for High Speed Optical Receivers

A 100GBaud Optical Receiver Front-End in 90nm SiGe BiCMOS

Gain-controlled semiconductor optical preamplifier for the 100 Gbit/s 40 km Ethernet receiver

A Monolithically Integrated 850 nm Optical Receiver Front End

A 110-to-130ghz SiGe BiCMOS Doherty Power Amplifier with Slotline-Based Power-Combining Technique Achieving >22dbm Saturated Output Power and >10% Power Back-off Efficiency.

A Hybrid Integrated TIA and PD for 20-Gb/s Optical Receivers

40Gbps Optical Receiver Based on Germanium Waveguide Photodetector Hybrid-Integrated with 90nm CMOS Amplifier

A Single-to-differential Broadband Transimpedance Amplifier for 12.5 Gb/s Optical Links.

Simulation and Fabrication of 5Gb/s Monolithically Integrated Optical Receiver Front End