Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Effect of Harmful Elements on Thermal Properties of Cokes in BF

Evolution of Coke Microstructure and Metallurgical Properties During Graphitization in a Blast Furnace

Performance influence study on blast furnace raw materials by zinc and pb

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Investigating effect of coke porosity on blast furnace performance based on multi-physical fields

Research on themetallurgical properties of coke used in Tangsteel ironmaking production

Effect of blast furnace coke graphitizing its high temperature metallurgical properties

Application of High‐ and Low‐Reactivity Cokes in Hydrogen‐Rich Blast Furnaces

Study on the High-Temperature Interaction between Coke and Iron Ores with Different Layer Thicknesses

Physical and chemical properties of metallurgical coke and its evolution in the blast furnace ironmaking process

Effect of water vapour on the interface reaction between carbon brick and molten iron in blast furnace hearth

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Evolution and process analysis of the hearth activity in hydrogen-rich blast furnace

Experimental Study on Effect of Flux Addition on the Sintering Harmful Gas Emission

The effect of alkali on the reaction kinetics and strength of blast furnace coke

Interfacial reaction behavior in blast furnace and analysis of influence mechanism

Relationship and Mechanism Analysis of Soft-Melt Dropping Properties and Primary-Slag Formation Behaviors of the Mixed Burden in Increasing Lump Ore Ratio

Influence of B2O3 on the Thermophysical Properties of Molten Blast Furnace Slag

Effect of gasification reaction on pore structure, microstructure, and macroscopic properties of blast furnace coke