Abstract:We proposed a novel kind of absolute capacitive grating displacement measuring system with both high accuracy and long range in a previous article. The measuring system includes both a MOVER and a STATOR, the contact surfaces of which are coated by a thin layer of dielectric film with a low friction coefficient and high hardness. The measuring system works in contact mode to minimize the gap changes. This paper presents a theoretical analysis of the influence of some factors, including fabrication errors, installation errors, and environment disturbance, on measurement signals. The measuring signal model was modified according to the analysis. The signal processing methods were investigated to improve the signal sensitivity and signal-to-noise ratio (SNR). The displacement calculation model shows that the design of orthogonal signals can solve the dead-zone problem. Absolute displacement was obtained by a simple method using two coarse signals and highly accurate displacement was further obtained while using two fine signals with the help of absolute information. According to the displacement calculation model and error analysis, the error in fine calculation functions mainly determines the model's accuracy and is locally affected by coarse calculation functions. It was also determined that amplitude differences, non-orthogonality, and signal offsets are not related to the accuracy of the displacement calculation model. The experiments were carried out to confirm the abovementioned theoretical analysis. The experimental results show that the displacement resolution and error in the displacement calculation model reach ±4.8 nm and ±34 nm, respectively, in the displacement range of 5 mm. The experiments and the theoretical analyses both indicate that our proposed measuring system has great potential for achieving an accuracy of tens of nanometers and a range of hundreds of millimeters.

Analyses of System Error in the Measurement of Liquid Crystal Empty Cell Gap by Means of Interferometry

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

Complementary of Phase Compensation Method to Measure Gap of Twist Nematic Cells

Uncertainty Analysis of Slot Die Coater Gap Width Measurement by Using A Shear Mode Micro-Probing System

Melt Level Measurement for the CZ Crystal Growth Using an Improved Laser Triangulation System

The Determination of the Interference Fringe Order in the Split-Beam Liquid Crystal Display Cell Gap Meter

Analysis of the Effects on Ultra-Short Laser Pulse Beam Quality Caused by Errors in Optical Systems

A Microscope Measurement System of Cellular Mueller Matrix

Error Analysis of a Spherical Capacitive Sensor for the Micro-Clearance Detection in Spherical Joints

Measuring Linewidth For Micro-Components Based On Regular-Reflective Triangulation Measuring Method

Error analysis and Modeling for High Accuracy

Research On Effects Of Phase Error In Phase-Shifting Interferometer

Measurement of Optical Aberrations of Liquid Crystal Lens

Exact surface measurement based on phase error insensitive method for white-light scanning interferometer

Analysis of Frequency Mixing Error on Heterodyne Interferometric Ellipsometry

Study on the measurement of in-plane displacement of solid surfaces by laser Doppler velocimetry

Study of interferometric signal correction methods in ultra-precision displacement measurement

Research of Measurement and Measuring Error of Laser Interferometer in Step Imprint Lithography

Measurement of small birefringence in PI of liquid-crystal

Error Analysis and Modeling for an Absolute Capacitive Displacement Measuring System with High Accuracy and Long Range.

Error Separation and Dynamic Compensation Method in Coplanar Planar Grating Displacement Measurement System