Abstract:Electrostatic actuation is widely used because of its rapid speed and low power consumption. The parallel-plate actuator is one of the most basic, but also most common electrostatic actuators for Micro Electro Mechanical System (MEMS) applications. The effective working range of parallel-plate actuator is limited to only one-third of the initial gap owing to the pull-in instability. Different strategies have been reported to extend the stable working range, but are mostly focused on improvement of the control circuit. In this paper, we aim to report some progress toward solution of the working range problem from the design of suspension beam. A suspension beam called “two-beam” is presented to achieve parallel-plate actuator with extended working range, but without penalties of complex control circuit and large actuation voltage. A bumper structure is employed in the design of two-beam to change the spring constant near the critical point of pull-in, and a two-layered polysilicon surface process is used to fabricate this two-beam structure. Theoretical calculation and numerical simulation indicate that the working range can be extended depending on the position and depth of the bumper. The fabrication of a 2×2 array of parallel-plate actuators suspended by four sets of two-beam is implemented, and a somewhat larger working range, i.e. about 50% of the initial gap is achieved in the experiment.

A Bi-Directional Out-of-Plane Actuator by Electrostatic Force

An Electrostatic Mems Spring Actuator With Large Stroke And Out-Of-Plane Actuation

Electrostatic repulsive out-of-plane actuator using conductive substrate

Design and Analysis of a Novel MEMS Out-of-Plane Actuator

A Gravity-Assisted Piezoelectric Inertial Actuator for Bidirectional Smooth Drives by Single Excitation Source

Out-of-Plane Comb-Drive Lever Actuator

Design of an Electrostatic Repulsive-Force Based Vertical Micro Actuator

Analysis of Characteristics of Micromachined Electrostatic Repulsive Actuator

Silicon-On-Insulator Out-Of-Plane Electrostatic Actuator with in Situ Capacitive Position Sensing

A novel single-layer bi-directional out-of-plane electrothermal microactuator

Laterally driven electrostatic repulsive-force microactuators using asymmetric field distribution

An Out-Of-Plane Electro-Thermal Polymer Actuator

A Magnetic Repulsive Force MEMS Actuator

A multi-electrode and pre-deformed bilayer spring structure electrostatic attractive MEMS actuator with large stroke at low actuation voltage

Electrostatic Comb-Drive Actuator for Mems Relays/Switches with Double-Tilt Comb Fingers and Tilted Parallelogram Beams

A Two-Beam Method for Extending the Working Range of Electrostatic Parallel-Plate Micro-Actuators

Electrostatically-Driven-Leverage Actuator as an Engine for Out-of-plane Motion

An Electrothermal Actuator With Two Degrees of Freedom Serving as the Arm of a MEMS Gripper

Design optimization of polymeric Out-of-plane electro-thermal actuator

A Novel Out-Of-Plane Electrothermal Bistable Microactuator

An electrothermal/electrostatic dual driven MEMS scanner with large in-plane and out-of-plane displacement